GMC Complaints

Transmission not shifting correctly. Have had the recall software update. Two new valve bodies and still not shifting correctly. Transmission is known to lock up.

The engine, while driving down the road, incurred a failure to the pusher rod in the #5 cylinder. This occurred at 6750 total miles on engine. Engine failure was repaired by a dealership. The failure occurred again at 99,500 miles to the same #5 cylinder causing major engine damage leading to the replacement of the engine. Our safety was put at risk as the truck decelerated and began vibrating. The second failure occurred and the engine shutdown. These incidents occurred without warning, Yes, a dealer was involved in both incidents. Only a dealership has been involved. The warning occurred after the failure.

The contact owns a 2018 GMC Acadia. The contact stated that upon arriving at her destination, the contact shifted into reverse to park the vehicle; however, after parking and shifting to drive(D), the vehicle failed to respond. The contact became aware after several attempts that the transmission was stuck in park(P). The blank warning light was illuminated. The vehicle was towed to the dealer, who diagnosed a failure with the inline shifter wiring harness. The vehicle was not repaired. After investigating the failure, the contact related the failure to Technical Service Bulletin: 19-NA-206. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 111,000.

The contact owns a 2021 GMC Sierra 1500. The contact stated while driving approximately 75 MPH, the rear wheels locked up. The failure had occurred on several occasions. The contact stated that several unknown warning lights were illuminated. The vehicle was towed to a dealer where it was diagnosed and determined that a software update was needed. The vehicle was repaired under an NHTSA Campaign Number: 24V797000 (Power Train); however, the failure persisted. The manufacturer was not notified of the failure. The failure mileage was approximately 35,000.

With out any warning the truck stop running at stoplight an would not start back up. We could not move the truck out of the road and blocked traffic for almost 1 hour waiting for the tow truck and getting it loaded on the tow truck (truck would not go in to neutral). The truck is now at the Dealer and they are saying that the engine seized up and will need replaced.

The truck bed cover is not secure, it fits in via a channel with no straps or other protections and so when driving on the highway, it flies off from the connection to the cab and you can’t see behind you. It then smacks into the car until you can pull over. There is no protection against this.

Driving down the road dash lit up to push start and truck shifted in to neutral. Pulled off the road and put in park. Engine would not start again. Dash kept lighting up with push start, turning off non essential to preserve battery. Called tow truck. They tried jumping, not the battery. Had to drag the vehicle on the flat bed because could not put in neutral. Drag and drop off the flat bed at the dealer. That was Friday. On Monday got the call the engine had seized. 34k miles Had just returned from a 2k mile trip with construction zones down to one lane and nowhere to pull off. Glad it didn’t happen there!

Motor blew up while driving down the road. Had to replace motor on 08/23/2023 at about 116,000 miles. Left me and my family stranded in the middle of no where. Was going around 60 miles an hour and when passing someone got up to 71 mph and then motor blown push rod bent. Transmission issues. Hesitation when switching from park to drive/ reverse. Takes at least 40 seconds and when you accelerate it will jerk so hard. Will lunge forward very sudden and sometimes even when coming to a stop at a stop sign. This happens almost every day.

N242490120 is applicable for 2022 models but my 2023 also had the same problem; The grille upper cover broke at the taps and detached from the grille structure.

Stalled while driving 3 weeks ago, was able to restart. Last Monday it died again on a shorter trop to store, it wouldn't restart. 3 days later, after having to go to Dealership was told engine 6.2L engine is being replaced. Potentially crankshaft bearings failing at 55,315 miles on it