2024 HONDA CR-V Complaints

I own a 2024 Honda CR-V EX-L with approximately 59,628 miles. While driving the vehicle, multiple warning lights began flashing on the dashboard. At the same time, the vehicle became difficult to drive and did not feel as though it was operating normally. I was concerned for my safety because the problem occurred while the vehicle was being driven. The vehicle was taken to two different authorized Honda dealership for diagnosis. I was informed that the fuel injectors had failed and needed to be replaced. The dealership quoted approximately $2,500 for the repair and told me that the fuel-injector failure was considered normal “wear and tear.” I am concerned that fuel injectors would fail on a 2024 Honda CR-V with only approximately 59,628 miles. I am particularly concerned because the failure was accompanied by multiple dashboard warning lights and made the vehicle difficult to drive. I believe this issue should be investigated as a potential safety defect because a fuel-injector failure that affects the vehicle's drivability could create a dangerous situation while the vehicle is being operated. I have contacted American Honda Motor Co. regarding the issue and requested that Honda review the fuel-injector failure for applicable warranty, emissions-warranty, service campaign, or goodwill coverage.

The contact owns a 2024 Honda CR-V. The contact stated that while at traffic light and holding steering wheel, there was a pinching on steering wheel and steering wheel was turning slowly. The failure was intermittent. The dealer was contacted and diagnosed the vehicle with rack and pinion failure. The contact was informed that the rack and pinion needed to be replaced. The vehicle was previously repaired under warranty; however, the failure reoccurred. The manufacturer was contacted by phone and was made aware of the failure. The failure mileage was approximately 8,000.

Steering feels sticky/jerky when turning left. Front-left tire outer edge is severely worn down, while other tires are normal. Honda recall 24V744 for steering gearbox was completed, but the problem persists. I suspect the steering rack is defective, causing misalignment and abnormal tire wear. This affects vehicle control and safety.

2024 Honda CRV. Battery went dead. Air conditioner stopped working. Honda dealership said the compressor is bad. Part is covered by warranty but must use a Honda part. Honda said part is not available nationwide. I live in Florida and temperatures exceeding 90 degrees. No estimated time for delivery.

The contact owns a 2024 Honda CR-V. The contact received notification of NHTSA Campaign Number: 24V744000 (Steering), and the vehicle was taken to the dealer, where the recall repair was completed; however, the failure occurred while driving. The contact stated that while driving at various speeds and turning, the steering wheel made abnormal sounds, was sticking, and failed to return to center. The vehicle was taken back to the dealer, where the contact was informed that a diagnostic fee was required, and the contact was asked to sign a document. The contact declined to pay the fee or sign the document. Additionally, the contact stated that the windshield wipers were malfunctioning, intermittently moving past the windshield trim and failing to touch the glass while operational. The dealer was notified of the windshield wiper failure. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failures. The failure mileage was approximately 90,000.

On August 20, 2026 at approximately 3:45 pm the vehicle slammed on it's brakes unexpectedly with the ACC active. The ACC was set to 45mph as per the speed limit and was traveling at that speed until the brakes suddenly engaged and abruptly reduced the speed to 20mph. It was sunny, 91 degrees there were no cars, obstructions or shadows and the vehicle had been washed and clean 2 days before.

Car accelerated unexpectedly when braking at a parking spot. Car accelerated over the curb and hit another car.

Upon driving steering appears normal then starts to feel a little tight as if I was loosing power steering then goes back to normal.

What component or system failed or malfunctioned, and is it available for inspection upon request? Wiper system malfunctions by allowing driver side wiper to intermittently reach varied end positions, sometimes striking the A-pillar. Vehicle is available for inspection upon request (has been inspected by dealer already). How was your safety or the safety of others put at risk? While driving in heavy rain, wiper erratically slamming into A-pillar is distracting and has caused me to try to adjust wiper speed and settings to prevent wiper arm from potentially breaking, which could be dangerous in certain higher speed conditions in heavy rain/low visibility. Has the problem been reproduced or confirmed by a dealer or independent service center? Yes, dealer was able to observe/reproduce the highly variable end position of the drivers side wiper. Dealer notes wiper shows up to 6 inch variance in where it stops. They could also see by the wiper marks on the windshield the variation in the end position. However, they compared the wiper function to another CRV and said it seems normal and refused warranty repair because the wiper was not broken or misadjusted at this time. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? No. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No warning lamps or messages. Symptom is recurring since purchase of the vehicle. However, the wiper only demonstrates the ability to strike the A-pillar during heavier rain and use of wipers for longer periods (which has not happened frequently during time I've owned/driven vehicle).

The windshield wipers and system of water delivery from the blades onto the windshield is a total disaster. You can easily have an accident due to extremely poor visibility after using the windshield wipers to clean the windshield with water, especially if the sun glares on your windshield which is now smeared not clean and reflects and refracts all the smear. You can't see and aggravates the driver. I almost did have an accident. Very scarry to have such poor visibility when you expect to clean your windshield not to smear it! Water is dispersed from the blades way too late in the sequence and the quantities are too small to perform a cleaning, not even a suboptimal one. I asked the dealer to fix the timer and it cannot be done. I also asked to allow more water to be deliver earlier in the sequence and that can't be done either. In addition, the water tank for the window cleaning is way too small as you try to keep cleaning since it only smears. Honda needs to address this issue. I was a Honda enthusiast since the early 90's, but I will never buy a Honda again if they don't change this design which is a total safety hazard. This happens all the time when you try to clean the windshield and it is dry outside. At least when it is raining the rainwater helps. I uploaded some pictures below that shows a “clean” smeared after trying 3 times to clean the windshield using new blades. Extremely unsafe and disappointing of Honda's "new" useless design. They can at least change the software to allow the service dealers to reset the time of the water delivery sequence to be instant when the blade is still down and to have more water be delivered. Currently the water delivery happens only when the blades made it up already, after they already smeared a dry window and in the mean time you lose all the water delivered at the point and the windshield is not clean, but smeared. I am retired engineer by profession and Honda can go back to the design board to come up with a fix.