2010 LEXUS HS Complaints

Car stops un-expectantly while driving, this caused the car to turn off and not be able to steer, then it turns back on without warning. This results in not being able to control the car. This resulted in being hit by three cars. It looks like Lexus listed a notice, however we did not receive it, and were not aware of the notice. Waring lamps did come on please see pictures.

A week ago I started hearing a clunking noise in the steering column. It would also clunk near the front left wheel when I turned steering wheel. I was told I need to replace the rack and pinion steering, tie rods, and steering shaft. This is a very expensive repair. My 2010 HS250h only has 98,000 miles. I have never-ever had to replace the rack and pinion steering in any car! (Nor has anyone I know.) I believe this is a serious safety issue, especially since there were no warning lights to alert me of this problem. I am totally shocked that this would happen in a LEXUS! There clearly must be a defect in the car. (Like there was with the brake booster pump that I had to replace a year ago.) Lexus needs to step up, acknowledge the defect, and reimburse.

I own a 2010 Lexus HS250H. the problem exists that every warning light associated with the braking, traction, and anti lock system is on. Anti-Lock Braking System (ABS), Traction Control System (TRAC), and Vehicle Stability Control System (VSC) The dealer said it was a faulty Brake de booster and said it was checked in 2010 and was fine. And to fix the system they need to replace the brake de-booster at a charge of $3000. Apparently, it is not fine, and requested them to comply with the recall and change the debooster, and they said no. Are they libel for the recall fix? Running Sequence Number: 96610 Campaign Number: 13V235000 Make: LEXUS Model: HS Year: 2010 and Running Sequence Number: 68016 Campaign Number: 10V039000 Make: LEXUS Model: HS Year: 2010

SAFETY RECALL GLK REAR LOWER SUSPENSION ARM No.1 CERTAIN 2010 MODEL YEAR HS250h was done previously in 2016 and epoxy was put on the lower control arms rendering the suspension not being able to be aligned by conventional means. The car is now out of alignment in the rear and cannot be adjusted due to the epoxy. Dealership states that once a recall is done it cannot be redone for free and it would be out of pocket. This service can only be done at certified dealership. The car pulls to the right and it swings, sways and drifts into corners and feels very unstable.

Taking left turn, heard a loud sound and complete loss of control of vehicle. Currently being inspected by Lexus dealership, although car was initially towed to dealership service center from which is was purchased. They mentioned lower control arm of rear suspension bolt was lost/missing and rear struts were shot and vehicle is unsafe to drive. I then paid for a second tow from dealership to Lexus dealership. No warning lights were lit except after total loss of control.

The contact owns a 2010 Lexus HS250 Hybrid. The contact stated while driving approximately 45 MPH in traffic, he depressed the brake pedal for slowing traffic ahead however, the brake pedal became firm and failed to respond as needed. The contact stated he depressed the brake pedal with more force and the vehicle started slowing down but did not stop as needed. The contact felt as if the brake pedal was jammed. The contact stated that the ABS and check brake lights were illuminated. The contact stated that the vehicle failed to stop as needed and only the forward movement of the vehicles in front kept him from crashing into the vehicle. The contact had the vehicle towed to an independent mechanic where it was diagnosed and determined that the brake booster needed to be replaced. The vehicle had not been repaired. The manufacturer had not been informed of the failure. The contact and the independent mechanic researched online and related the failure to NHTSA Campaign Number: 13V235000 (Service Brakes). The failure mileage was approximately 193,000.

Same transmission issue that was recalled is having same issues. Recall was not resolved.

I have a 2010 HS 250h with 90,000 miles. Out of the blue, the brake actuator started activating every 10 seconds (and even runs for a while once car is shut off) and there is a noise coming from brake pedal area when depressed. Lexus had previously recalled some 2010 HS 250 cars for brake booster pump issues. My VIN was not part of the recall; I dreaded this day would come. Toyota/Lexus is well aware of the brake booster pump issues in their hybrids. Dealer confirmed the issue and now it will cost me $3500 to have a problem fixed that Lexus should have handled a long time ago. I've contacted Lexus corporate and they will not fix the car. I hope the NHTSA will look into all the complaints about this issue and 2010 HS 250h cars. Lexus needs to step up and issue another recall.

The contact owns a 2010 Lexus HS250 Hybrid. The contact stated while her daughter was driving at an undisclosed speed, the brake pedal was depressed but felt stiff and the vehicle failed to respond. There was no warning light illuminated. The contact's daughter swerved between vehicles to prevent a crash. The contact's daughter continuously depressed the brake pedal until the vehicle responded. The contact's daughter veered to the side of the road. The vehicle was towed to an independent mechanic who informed the contact that the brake booster pump had failed. The vehicle was then towed to the dealer, where it was diagnosed that the brake booster pump had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure but offered no assistance. The contact was informed that the VIN was not included in NHTSA Campaign Number: 13V235000 (Service Brakes). The failure mileage was approximately 150,000.

The contact owns a 2010 Lexus HS 250 HYBRID. The contact stated that while driving approximately 20 MPH and attempting to apply the brake, the brake pedal went to the floor and failed to stop the vehicle. The vehicle began to swerve and displayed a tugging with the steering wheel. The contact was able to turn into a grassy area to the right where the vehicle eventually stopped. The brake master warning light, brake warning light, electronic brake control, ABS, and traction control warning lights are illuminated. The vehicle had begun making a humming then grinding noise. The failure reoccurred intermittently while driving at various speeds and more consistently. The contact learned that the failure was an indication that the actuator had failed. The contact had not taken the vehicle to the dealer. The vehicle had not been diagnosed or repaired. The manufacturer was made aware of the failure and opened a case. The approximate failure mileage was 110,000.