2010 LEXUS HS Complaints

The contact owns a 2010 Lexus HS250 Hybrid. The contact stated that while her daughter was attempting to reverse, the vehicle would not accelerate. The vehicle was towed to the dealer to be diagnosed. The contact was informed that the transaxle assembly needed to be replaced. The vehicle was not repaired. The manufacturer was contacted and informed that the vehicle had experienced the failure listed in NHTSA Campaign Number: 17V619000 (Electrical System) for which the vehicle was previously repaired. The manufacturer stated that the warranty for the repair had expired. The failure mileage was 1,030.

The previous recall on this issue is not completely resolved. The rear suspension on this model of Lexus was simply epoxied in place permanently. The recall "resolution" approved by NHTSA and implemented by Lexus does not allow for the common maintenance on the vehicle - namely, alignment. Therefore, inordinate and substantial tire wear occurs due to the inability to align the wheels. The only way to “align” the tires is to buy completely new suspension parts (approximately $900) which will then be permanently epoxied in place again. Instead of the normal alignment ($100) again in an expected maintenance period, the Lexus dealer requires entire replacement again. This recall was NOT repaired. This recall was permanently and unsafely epoxied in place without the possibility of alignment needed for safety. It is unsafe to drive a car that cannot be aligned properly. Tire failure is a real and present danger. My tires were excessively worn and could have blown out.

The contact owns a 2010 Lexus HS250 Hybrid. The contact stated while driving approximately 45 MPH, the contact depressed the brake pedal to avoid traffic however, the brake pedal felt loosened and the vehicle started to swerve from the left to the right. Additionally, the contact stated that the steering wheel was loose causing the vehicle to swerve from left to right. The contact stated that the ABS, brakes, and an unknown warning light was illuminated. The contact stopped the vehicle and drove back to her residence. The contact had not taken the vehicle to a local dealer or independent mechanic to be diagnosed. The contact stated that the failure persisted. The vehicle had not been repaired. The manufacturer had not been informed of the failure. The failure mileage was approximately 161,000.

Recall for Rear Suspension arms. There was a recall on my car which was processed in Aug 2016 at 89k miles by previous owner. I purchased the car in Dec 2021-Jan 2022 at around 93-94k miles. This means the car was almost not used by previous owner for 5 years as the recall wasn't performed well Also, the label for "safety recall" is still on the entire rear suspension arms which proves the point. When i called the dealership, they mentioned they never ever leave the stickers ON after the recall is processed which is contradictory to the repairs done. This is a serious safety issue and Lexus is liable to fix this recall but they are asking me to pay for it. I do not have any extra money to keep spending just because of the recalls not processed correctly. It goes with the brand Lexus which i trusted to buy. Recall is not done correctly which is a FACT. After driving for few months and just around 3-4 k miles the new tires are completely destroyed. This is when my wife was doing on freeway this happened which is very scary and serious safety concern. Attaching the pictures and certificate of recall repairs, if you can help in this regards.

Fuel leak in fuel pump caused my car to completely stop on the highway. No warning lights came on. Lexus company denies that my car was not part of the recall for the fuel pumps on the Lexus HS250 even though multiple issues reported for the fuel pump for this make an model,

Initially, the ABS, BRAKE, and Anti-skid lights illuminated on the instrument panel and braking began to be spongier than normal. This condition continued for approximately 4 years. The brake system now has failed and braking is extremely slow. The car began beeping constantly while on with or without the engine running. This latest error took place while driving at approximately 55mph, soon after a car entered the highway (4 lanes) in front of me, I braked but the brakes did not actuate properly increasing the stopping time and distance. Luckily, I was able to move to the left-hand lane and avoid a collision. This occurred on February 13, 2022 AutoZone pulled the following codes: C1241, C1252-Hydro-booster pump motor malfunction, C1253-Hydro-booster pump motor relay malfunction, C1256-Accumulator low-pressure malfunction, C1311-Open circuit in main relay 1, and C1391-Abnormal leak of ACC PRESS (All except C1241 are related to the braking system) No one has inspected the component. I was able to locate NHTSA Recall Bulletin Reference #10V039000 (SERVICE BRAKES, AIR:ANITILOCK:CONTROL UNIT/MODULE) that references Lexus HS250h models manufactured up to February 2010, yet my VIN doesn't pull up this bulletin when searching the database even though it was manufactured in February of 2010.

The contact owns a 2010 Lexus HS 250 Hybrid. The contact stated that while driving and depressing the brake pedal, the pedal extended to the floor causing the braking distance to be extended. The vehicle was taken to an independent mechanic who diagnosed that ABS booster was faulty and needed to be replaced. The vehicle was not repaired. The manufacturer and local dealer were not notified of the failure. The approximate failure mileage was 197,000.

The brake booster pump/accumulator has a diagnosed internal leak. It is identical to Toyota Safety Recall 13V-235 for Certain 2010 Model Year HS250h Vehicles. The exact failure described is what my Lexus HS 250h is experiencing and the DTC code is C1391, which FOUR separate shops have verified. The recall listed DTC C1246 and C1256, yet the condition is that there is an internal leak and one must replace the booster pump master assembly. They describe it as following, "The subject vehicles are equipped with brake pressure accumulators consisting of a metal plunger containing brake fluid encased in a metal housing. The plunger is designed with metal pleated bellows to allow for motion. Nitrogen gas is sealed between the plunger and housing. There is a possibility that a fatigue crack could develop in the bellows due to the vertical vibration of the plunger while driving. If this occurs, nitrogen gas could leak into the brake fluid and gradually cause the brake pedal stroke to become longer, resulting in decreased hydraulic pressure. Under certain circumstances, this condition could affect stopping distance and increase the risk of a crash." I have record they did try a repair for this at 17 miles, before purchase, but it clearly DID NOT remedy the situation. After 80,000 miles with a gently driven car they should be required to :Replace the brake booster pump assembly (accumulator) AND the brake booster assembly. The remedy described in the recall information . Out of three repair shops, three have indicated that they cannot make the repair due to Lexus parts or warranty. It is at a Lexus repair presently.

The contact owns a 2010 Lexus HS 250 Hybrid. The contact stated that while his wife was driving approximately 45-50 MPH, the brake pedal was depressed but felt soft. The brake warning light, the ABS warning light, and the speed warning light were illuminated. The contact’s wife veered to the side of the road. The vehicle was towed to the contact’s residence. The vehicle was then taken to the dealer who diagnosed that the brake accumulator needed to be replaced. The contact referenced NHTSA Campaign Number: 13V235000 (Service Brakes). The manufacturer was not notified of the failure. The vehicle was not repaired. The approximate failure mileage was 145,900.

The contact owns a 2010 Lexus HS 250 Hybrid. The contact stated that while driving on rough pavement and applying the brake, the vehicle jolted forward nearly crashing into another vehicle. The vehicle was taken to the local dealer who was unable to duplicate the failure. The mechanic found no failure with the vehicle. The contact was informed that the VIN was not included in NHTSA Campaign Number: 10V039000 (Service Brakes, Air). The contact indicated that the vehicle had experienced the failure listed in the recall. Also, while driving the engine light suddenly illuminated and the vehicle should off. The vehicle was towed to the local dealer who diagnosed that the engine battery had failed. The contact indicated that the vehicle was previously serviced under the NHTSA Campaign Number: 17V619000 (Electrical System). The manufacturer was notified of the failure. The approximate failure mileage was 75,000.