2010 MAZDA MAZDA3 Complaints

MY POWER STEERING SUDDENLY GAVE OUT WHILE DRIVING ON A CITY STREET. IT IS NO LONGER WORKING. I WAS TOLD BY A MECHANIC THAT THE POWER STEERING HYDRAULIC PUMP NEEDED TO BE REPLACED. IT WAS REPLACED BUT THE POWER STEERING IS STILL NOT FUNCTIONING. IT'S EXACTLY THE SAME. THERE WAS AND IS NO LIGHT LIT UP ON MY DASHBOARD INDICATING A POWER STEERING FAILURE; YET THE POWER STEERING IS NOT WORKING AT ALL. THE CAR MUST BE STEERED WITH MANUAL FORCE/MUSCLE, ESPECIALLY WHEN DRIVING SLOWLY OR WHEN STOPPED.

TL* THE CONTACT OWNS A 2010 MAZDA MAZDA3. THE CONTACT STATED THAT WHILE DRIVING AT 35 MPH, THE FRONT DRIVER'S SIDE SEAT TILTED FORWARD INDEPENDENTLY AND THEN DETACHED FROM THE TRACK. THE VEHICLE WAS TAKEN TO A DEALER WHERE IT WAS DIAGNOSED THAT THE SEAT NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 118,000. THE VIN WAS UNAVAILABLE.

MY DASHBOARD IS MELTING AND CAUSING A DANGEROUS GLARE DURING DAY TIME DRIVING. 60% OF THE TOP DASH IS MELTING AND DOES NOT DRY OR GO BACK TO NORMAL. ALWAYS STICKY AND DANGEROUS DURING SUNNY DAYS DUE TO GLARE REFLECTING OFF MELTED SURFACE.

DASHBOARD MELTING. THE DASHBOARD HAS MELTED. IT CAUSES A SEVERE GLARE ON THE WINDSHIELD THAT MAKES IT DIFFICULT TO DRIVE AT TIME. HAVE HAD TO COVER UP WHEN THIS OCCURS.

MY DRIVERS SIDE SEAT BRACKET HAS BROKEN CAUSING THE SEAT TO ROCK SLIGHTLY. ALSO, THE DASHBOARD APPEARS TO BE MELTING WITH A SHINY STICKY SPOT.

COPIED FROM AN EXISTING COMPLAINT BECAUSE I HAD THE EXACT SAME PROBLEM: THE SWING ARM THAT ATTACHES THE DRIVER'S SEAT TO THE LEFT-SIDE SEAT RUNNER UNEXPECTEDLY DETACHED. CLOSE INSPECTION REVEALED THAT THIS WAS CAUSED BY A WELD FAILURE / METAL FATIGUE AT THE POINT WHERE THE ARM WAS WELDED TO THE ROD THAT RUNS BELOW THE CUSHION. THE SEAT IS NOW UNSTABLE AND ROCKS IN AN ALARMING WAY, BOTH WHEN ACCELERATING AND DECELERATING. THE FAILURE OCCURRED WITH A POPPING NOISE AS I PREPARED TO PULL AWAY FROM A PARKING SPOT.

TL* THE CONTACT OWNS A 2010 MAZDA 3. WHILE DRIVING VARIOUS SPEEDS, THE RADIO ACTIVATED INDEPENDENTLY. THE RADIO TURNED ON AND OFF WHEN THE BRAKE PEDAL WAS DEPRESSED. IN ADDITION, THE WINDOWS FAILED TO WORK INTERMITTENTLY. THE VEHICLE WAS NOT DIAGNOSED NOR REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURES. THE APPROXIMATE FAILURE MILEAGE WAS 130,000.

TWICE NOW, WHEN I WAS ALERTED VIA MY TPMS THAT I HAD LOW TIRE PRESSURE IN ONE OF MY TIRES, I STOPPED AT A SERVICE STATION TO ADD AIR TO MY LOW PRESSURE TIRE. AS I APPLIED THE AIR HOSE TO THE VALVE STEM, THE VALVE STEM (AND THE ATTACHED TPMS SENSOR, DISAPPEARED INTO THE WHEEL AND TIRE AND THE TIRE WENT IMMEDIATELY FLAT. . I BELIEVE THIS TO BE THE RESULT OF FAULTY DESIGN OF THE TPMS ASSEMBLY. THE MATERIALS USED IN THE COLLAR AND NUT THAT SECURE THE TPMS ASSEMBLY TO THE WHEEL IS NOT APPROPRIATE FOR THE ENVIRONMENT (EXPOSED TO ROAD SALT, DIRT, GRIME, BRAKE DUST, ETC.) IN WHICH THE TPMS ASSEMBLY MUST FUNCTION. THE COLLAR AND NUT CORRODE AND EVENTUALLY FAIL DUE TO THAT EXPOSURE. FORTUNATELY FOR ME, I WAS STOPPED AT THE TIME OF THOSE FAILURES; HAD I BEEN TRAVELING AT HIGHWAY SPEEDS THE COMPLETE FAILURE (NO AIR PRESSURE REMAINING IN TIRE) COULD HAVE BEEN CATASTROPHIC. THE FIRST ASSEMBLY FAILED AT APPROXIMATELY 36,500 MILES AND THIS MOST RECENT ONE FAILED AT 61,800 MILES. BOTH TPMS ASSEMBLIES WERE OEM PARTS AND WERE INSTALLED ON THE VEHICLE WHEN WE BOUGHT THE CAR NEW FROM MAZDA. I HAVE SEEN MANY REPORTS ONLINE DESCRIBING SIMILAR FAILURES. TO THE BEST OF MY KNOWLEDGE, MAZDA HAS NOT YET RECOGNIZED OR ACKNOWLEDGED THIS AS A PROBLEM WITH THE DESIGN AND FAILURE OF THEIR TPMS ASSEMBLIES. I WOULD LIKE THEM TO ACKNOWLEDGE THE PROBLEM AND TAKE ACTION TO ADDRESS THEIR FAULTY DESIGN, BEFORE SOMEONE GETS HURT OR DIES FROM AN ACCIDENT RESULTING FROM ANOTHER TPMS ASSEMBLY FAILURE.

THE SWING ARM THAT ATTACHES THE DRIVER'S SEAT TO THE LEFT-SIDE SEAT RUNNER UNEXPECTEDLY DETACHED. CLOSE INSPECTION REVEALED THAT THIS WAS CAUSED BY A WELD FAILURE / METAL FATIGUE AT THE POINT WHERE THE ARM WAS WELDED TO THE ROD THAT RUNS BELOW THE CUSHION. THE SEAT IS NOW UNSTABLE AND ROCKS IN AN ALARMING WAY, BOTH WHEN ACCELERATING AND DECELERATING. THE FAILURE OCCURRED WITH A POPPING NOISE AS I PREPARED TO PULL AWAY FROM A PARKING SPOT. I PURCHASED THE CAR NEW AND HAVE TREATED IT GENTLY. I AM A SKINNY GUY AND HAVE AT NO TIME BEEN ROUGH ON THE SEAT. I AM SURPRISED THAT THERE IS NO RECALL ON THIS FAILURE AS IT IS CLEARLY A SAFETY ISSUE.

FRAME BRACKET BROKE WHILE DRIVING IN TOWN ON THE FRONT DRIVER SEAT CAUSING THE SEAT TO ROCK COMPLETELY BACK