2012 MAZDA MAZDA3 Complaints

The contact owns a 2012 Mazda Mazda3. The vehicle was transported from the east to Texas, and the vehicle was bought used. The contact stated that the dashboard was sticky and that a gap was between the instrument panel and cover. The contact stated that a small to medium bubble had started to form. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 100,000. The VIN was not available.

The car leaks gas when the tank is full and if the car is inclined slightly. I've noticed the problem several month ago with an occasional odor but finally saw the gas leaking recently when it was parked on a sloped street.

The brake pedal is soft and sometimes unresponsive unless it is pumped repeatedly. There have been several times where I have been concerned if I would come to a complete stop. I have had both sets of brake pads replaced in the last year, and have on driven 9,000 miles. Two independent service centers diagnosed the problem as a faulty master cylinder. However, upon replacing the master cylinder and doing three brake flushes, and inspecting my brake pads and calipers, the problem persisted and is unresolved. They directed me to order a new ABS module, believing that that is the only other part that could be causing the cars brake problems. This part (BFY1437AZCO) is on backorder until November 2025.

The Seat Lifter on the driver's side seat frame broke, the metal has a clear stress fracture right near the bracket where the frame connects to the rail. This is the same part that was recalled in the 2010 and 2011 Models by Mazda in 2017. NHTSA Campaign No. 17V-082 It causes the driver side seat to change positions while driving creating hazardous conditions and does not appear structurally stable if involved in an accident potentially putting the driver's life at risk.

Our fuel tank is leaking for no reason. Brought it in last year (2024) for state inspections and let them know we smell gas when we park sometimes. They poke around and find nothing, but note there is a faint gas smell and to bring it to the dealer. We take it to Mazda to see if they can fix, they find nothing and charge my wife $250. Fast-forward to a year later, go for the same state inspection and we get failed. Our mechanic says theres a noticeable gas leak from the fuel tank and to take it to Mazda. There is clearly some issue with the fuel tank parts. The car itself only has 77k miles and it is 13 years old.

The contact owns a 2012 Mazda Mazda3. The contact stated that after refueling the vehicle, there was an abnormal gasoline odor inside and outside the vehicle for the next 5 days, prompting the contact to only fuel the vehicle halfway. The contact observed fuel leaking underneath the vehicle near the fuel tank. No warning lights were illuminated. The vehicle was taken to an independent mechanic, who diagnosed a failure with the welded fuel tank nipple fuel line connector. The contact stated that the component was cracked along the bottom of the weld. The contact was informed that the fuel tank needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 81,000.

2012 Mazda3i 5dr hatchback. Persistent issue with headlights, both low beam and high beam, as well as interior lighting and other lighting. The headlights flicker for several seconds any time the brake pedal is applied. Interior lighting also flickers when brake pedal is applied. Headlights sometimes flicker when vehicle is decelerating and no brake pedal is applied, most notable when vehicle is traveling downhill. Further, the luminosity (brightness) of the headlights visibly dims, but does not flash, when the vehicle is parked and the brake pedal is applied. A high volume of others report the same issue, including documented complaints. These vehicles are unsafe, defective as designed, and do not conform to FMVSS No. 108. NHTSA must investigate further. Many other owners are not aware of the cause of the issue and attempt to fix it by replacing headlights, alternator, etc. Mazda was aware of issue prior to July 2013, when it issued TSB 01-019/13. This document states, "Some vehicles may exhibit the headlights flickering when the vehicle is decelerating (by applying the brakes) with the headlights on. This concern is caused by inadequate alternator output (controlled by the PCM) when the battery is under a heavy load. To correct the problem, the control logic of the PCM has been changed." This appears to be at best a temporary fix. Bommarito Mazda in Missouri required payment of $199.88 to "diagnose" this problem and address it in the manner prescribed in TSB 01-019/13. This service was not covered under warranty. Service Manager M.D. claimed to have never heard of this issue before and that it would need to be diagnosed, despite being informed by the owner of the precise issue, that others reported experiencing the same issue, and that others reported the issue was addressed by reprogramming the PCM. Immediately following this service, the headlights continued to visibly dim when the vehicle is parked and the brake pedal applied.

The Mazda dealership reported to me the push rod was broken, that it ‘just snapped’. The car was towed by Zaben towing company courtesy of the auto insurance company associated with the vehicle to the Mazda dealership, however the towing company was on its way to another Mazda dealership per their app despite a clear address location given by the purchaser of the auto insurance. I found one of the hubcaps missing and placed in back seat of the Mazda after delivery and the Mazda not parked properly at Mazda dealership. The hubcap was not in back seat prior to the drop off. The clutch snap, as described by Mazda, did not happen while I was driving the vehicle. It was working perfectly fine two days prior to the discovery of collapsed clutch when I was driving around town. The clutch was found not working, collapsed after the car was parked for two days. Also, Texas Mazda dealership recommended another eight hundred dollar worth of work totaling near two thousand dollars yet I have between ninety and ninety six thousand miles on a twenty twelve Mazda three sport sedan. I mainly drive it in the city. The Mazda dealership recommended the valve cover and slave cylinder be replaced as well. They need to clean out air system, ‘bleed system’ too.

Weak braking and spongy brake pedal created near accidents at highway speeds. Brake pedal needs to be pumped to get firmness. But the check engine warning light did not come on, either. So I had mechanics replace front rotors, front disc pads, and bleed/refill system with fresh brake fluid and inspect system for leaks. But spongy brake pedal problem was not fixed. So when I researched the problem on the internet, it appears that it's a systemic, long-time (10 model years or more) safety issue with Mazda that they failed to recall nationwide. Totally irresponsible. Among Mazda owners, after replacing all other brake system components and not solving the spongy brake pedal issue, it turned out to be a faulty ABS System Module, a $2,000 to $3,000 repair at Mazda dealerships.

Car started jerking and on the way home, the car lost all power to the transmission. The check engine light came on as well as the AT and traction lights. Absolutely no power to the transmission. codes P0780 and P0751.