2012 MAZDA MAZDA6 Complaints

Passenger dash has cracked some and dash is very very sticky..why has this happened..I feel if airbag had to deploy it would not because of this situation

The rear subframe and suspension parts are rusted so bad that the car is not safe to drive. Looked up recalls and found out the front subframe had a recall and was taken care of before I bought the car. Also found recall for my model of car that were registered in state that use salt on there roads which is one of the state i live in. Was told my Mazda corporation the only certain 2012 mazda vehicle's vehicle's were covered for rusting issues with the rear . If the front of the car is recalled and the same problem happens with the rear of the car shouldn't it be covered for something? I have an appointment coming up on the 21 of January which is ridiculous that I have to wait 3 weeks to have it looked at. . Thank you for your time. The only reason I found the problem with the car was a stick got stuck in the rusted out parts and when I took it out a bunch of rust fell on the ground.

The contact owns a 2012 Mazda Mazda6. The contact stated while driving 55 MPH and crossing a bridge, the vehicle stopped unexpectedly after driving over several expansion joints. The contact stated that the vehicle had not stalled. The contact exited the vehicle and noticed that the passenger’s side front wheel was slanted into the wheel well. The contact inspected the wheel well and noticed that the control arm had sheared off at the cross member. The contact stated that prior to the failure, the steering wheel had turned slightly to the right. The contact researched online and related the failure to NHTSA Campaign Number: 19V323000 (Structure, Suspension), which included the VIN. The contact stated that the vehicle was towed to a dealer, where the contact was advised that the VIN was included in a recall, and the contact was advised that the vehicle needed to be diagnosed to determine the cause of the failure. The contact stated that the dealer had not diagnosed vehicle in a month. The manufacturer was informed of the failure and advised the contact to work with the dealer. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer and dealer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 188,000.

The contact owns a 2012 Mazda Mazda6. The contact stated while driving 55 MPH, the steering wheel began to shake violently, with the low tire pressure warning light illuminated. The contact pulled over to inspect the vehicle and discovered that the front passenger’s side tire had detached from the vehicle. The contact's father was called to the scene and the spare tire was placed on the vehicle. The contact then drove to an independent mechanic where both the front driver’s and front passenger’s side tires were replaced. The manufacturer was notified of the failure and referred the contact to the dealer for assistance. The vehicle was taken to the dealer where a diagnostic test was performed; and the diagnostic test determined that the cross member had corroded and caused the tire failure. The contact was then notified that the vehicle was not covered under NHTSA Campaign Number: 19V323000 (Structure, Suspension) and that the warranty on the vehicle had expired. The vehicle remained in the possession of the dealer and was not repaired. The failure mileage was 204,000.

Front subframe completely rusted out causing loss of steering. I believe this should have been covered by Safety Recall 2818I which addresses the issue. Mazda inspected and said because the recall was performed in 2019 on this car, there is nothing more they can do, once and done. Unfortunately their fix didn't take care of the issue.

My 2012 mazda 6 Subframe is is unsafe to drive due to over-time corrosion My local mechanics said Madzda Corp. should fix it.

Rear sub frame, critical fail- rusted through. Needs new rear subframe. Wheel pulling to right, unable to align. I bought this car 2 weeks ago for my 16 year old daughter and was told today it needs to be scrapped. She is devastated . We are out 4500 with no recourse. I bought a Mazda because I trusted the safety. I am so disappointed. If the front was recalled the rear should have been too.

The passenger dash board is melting. It covers the passengers air bag. I would like to know if a recall is still possible for my vehicle. I understand that there was a recall in 2015-2017, but unfortunately I did not received the notice since I was moving from Illinois to Kansas and later to Texas and continued changing addresses during that time frame.

I was driving down the road when my steering, suddenly and with out warning began pulling very hard to the right and the steering wheel began turning to the left. My car made loud noises when I tried to straighten out the steering wheel and when I tried to turn. Its also appeared to be rubbing on the inside of the wheel well. Further inspection revealed that the support where the control arm is connected to the frame had torn away from the frame due to oxidation. There is significant oxidation on the frame and there are large areas that no longer appear to be solid.

The passenger side Dash on my 2012 Mazda 6 that I just purchased 3 years ago is melting and deteriorating and it's cracked and its leaves a real bad glare on the windshield and I think they said it was a recall that was back in 2015 but this car was never fixed and that recall wasn't fixed so how do I go about getting that recall fixed because when I talk to [XXX] at Mazda direct and Fostoria they said that there was nothing they could do and it is a real bad safety hazard. INFORMATION Redacted PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6).