MAZDA Complaints

Coolant leaks at cylinder head on 2019 Mazda CX-5 Grand Touring Reserve. Mazda North American Operations released a technical service bulletin (01-013/21) regarding 2016-2020 Mazda CX-5, CX-9, and Mazda6 with SKYACTIV-G 2.5T engines. This issue can cause the engine to leak coolant, overheat, and stall, potentially leaving the driver and passengers stranded in an unsafe location. Mazda is aware of this manufacturing defect but has not recalled these engines to be repaired or replaced if they are outside of their manufacturers warranty period and placing costly repairs and potentially life-threatening situations as the responsibility to their customers. The diagnosis to repair this issue is a replacement of the cylinder head/sleeve or replacement of the engine block, which has since been modified by Mazda to resolve this issue. This is a costly repair for diagnostics, labor hours, and parts and Mazda is refusing to be held responsible for these defects outside of the power train warranty period. Mazda customer support advised this will only be potentially covered if diagnostics are completed at a Mazda dealership and does not provide any assistance if the customer uses a non-Mazda affiliated repair shop. Messaging on the dash console advised excessive heat and thermostat was nearing 260°F

Low oil level message on cluster 1000 mile away from my oil change mileage indicated by the dealer.

The contact owns a 2016 Mazda MX-5. The contact received notification of the NHTSA Campaign Number: (Air Bags); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

Car has under 14k miles on it. There have been 2 instances going from a stopped to rolling with no foot on the accelerator to turn sharply out of a parking lot where when turning sharply to maneuver the vehicle surges forward and accelerates quickly on its own. It is concerning because both times I was in a small, confined area making turns out of a lot. I do not want an accident to occur due to this issue.

The Collision Avoidance System did not activate, to avoid a front-end collision. The vehicle in front of me stopped, making a right-hand turn onto another road. I moved forward, not seeing him stop. My car rear-ended the vehicle in front of me, with no warning or activation from my system.

The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that the back-up camera screen image was flickering and became distorted while reversing. The cause of the failure was not determined. The failure mileage was 60,000. VIN tool confirms parts not available.

The vehicle accelerated on its own, while I was parking. My foot was on the brake when the vehicle just took off. It continued to accelerate until a building stopped it. I continued to brake but the vehicle did not stop. Once the vehicle collided with building, saw on the digital read out the "Brake System Malfunction" and then Camera Malfunction. The vehicle was towed from the site and the insurance adjuster has sent me word that the vehicle is a total loss.

2009 Mazda 6 Rear subframe and springs are deemed unsafe due to extreme rusting and corrosion. The vehicle is registered and has been registered in both NY and PA (salt states), however was regularly washed and garage maintained. Vehicle will no longer pass inspection due to this issue and Mazda indicates no recall for the rear at this time and is ignoring that this is a highly prevalent issue. Mazda recalled and acknowledged this issue on these makes/models related to the front; however refuses to acknowledge and repair/recall the issue extending to the rear. The vehicle is in otherwise good shape, and the extreme rusting to the subframe/springs is not consistent with normal wear and tear. This is an extremely prevalent issue arising to these vehicles being ignored by Mazda. Mechanics are indicating the issue is extremely deteriorated and not safe, but that the vehicle is in otherwise good shape and the issue is consistent with faulty parts.

Started smelling smoke randomly and discovered an apparent oil leak in the engine. Mechanic inspected and noted that it appears to be an issue relating to the cylinder head/head gasket, which is in line with a technical services bulletin put out by Mazda several years ago for this make/model/year for a known design flaw that can result in catastrophic engine failure. I am just outside the five year warranty but well under the 60,000 miles, so expecting them to tell me they won't cover the repair even though this should have been a recall due to the potential outcome. I cannot drive the vehicle until this is repaired because it can cause engine fires (or worse).

First warning was the oil light came on and I became aware of a leak. When I took it to the mechanic the next day, he described a porous spot on the side of the cylinder head that had opened up and was rapidly losing oil when the engine was running. I understand that this is not a unique problem to my vehicle but is common with this model year. I am concerned that the engine will run out of oil and malfunction causing loss of control at highway speed. The car is currently scheduled for confirmation of the problem with the local Mazda dealer.