MAZDA Complaints

Back brakes arent gripping, caliper isn’t working been changed quite a few times. Either the abs or electric brakes

The contact owns a 2019 Mazda CX-5. The contact stated while driving 35 MPH, the vehicle was smoking. There were no warning lights illuminated. The vehicle was taken to the local dealer but was not diagnosed or repaired. The vehicle was taken to an independent mechanic, who determined that there was oil leaking from the main gasket and referred the contact to the dealer. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 31,000.

The contact owns a 2018 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that while shifted into reverse(R) and reversing out of the driveway, the rearview camera image was flickering on the display screen. The contact stated that the flickering was intermittent but eventually the camera became inoperable. The contact had notified the manufacturer of the failure. The failure mileage was approximately 38,000. VIN tool confirms parts not available.

Vehicle steering failed and caused the vehicle to go in opposite direction than intended, ended up almost hitting a streetlamp due to this. Issue had happened before and ended up on opposite side of traffic but had attributed it to loss of traction and wet weather at the time, but likely related to this. reported to dealer and they were unable to recreate or find any issue

The contact owns a 2016 Mazda CX-5. The contact stated that the daytime running lights were significantly dimmed while driving. The vehicle was taken to the dealer, where it was determined that the failure was related to NHTSA Campaign Number: 20V063000 (Exterior Lighting); however, the VIN was not included. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 60,000.

I bought this car brand new with 51 miles on it on 7/24 and have taken it to the dealership mechanics twice for the same problem. Within 3 seconds of “letting go” of the steering wheel, the car veers and pulls directly into the right berm. The car requires continuous redirection of the steering wheel to get it to drive straight on. The dealership where I purchased this has not reported this defect to the manufacturer despite me requesting it. The car was inspected prior to me purchasing it, and upon me noticing that it veers off the road, I took it back to the dealership garage (on 7/31) and the mechanics reported that they had rebalanced and realigned the tires.The mechanics also told me they had realigned the front and rear axles and said that they had probably been affected by being strapped down tightly on the delivery truck (?). I picked up the car the same day (7/31) after they said they fixed it, and within 10 miles of leaving the dealership, I noticed that the car continued to pull me off the road to the right. I turned around and returned to the mechanics’ and requested they report this to the manufacturer. The car has remained at the dealership mechanic’s since 7/31. No warning lights or messages have ever shown on the car. I consider this a major safety hazard as the car is constantly and consistently veering either off the road into the berm, or into the right lane if attempting to pass.

The infotainment system sometimes has "ghost touches" where random buttons on the screen are pressed without a physical press. This is dangerous because it is extremely distracting to the driver. It often changes songs or calls a random person on my phone contact list. This requires me to quickly and constantly press the "back" button for the infotainment system to prevent it from placing a call. This forces my attention and hands away from the core task of driving while the car is in motion.

The contact owns a 2018 Mazda Mazda3. The contact stated while reversing, the rearview camera image was distorted and failed to display on several occasions. There was no warning light illuminated. The vehicle was taken to the dealer, where it was diagnosed that the rearview camera had failed and needed to be replaced. The vehicle was not repaired. The contact later received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was unknown. VIN tool confirms parts not available.

The recall related to the rear backup camera has not been addressed and it is more than a year later. I just got off the phone with a Mazda representative and they still do not have a solution nor know when one might be available. I would like to sell my car but with a defective backup camera and view screen, I will have trouble doing so and/or won't get as much for the vehicle as I should. I have a 5 year old and I don't feel safe driving this vehicle, as the rearview camera turns off suddenly at times when I am reversing the vehicle. I would like to submit a compliant for negligence on Mazda's part and urge you to do something to make them fix this defect. Thanks.

While driving on the freeway the check engine light came on. I was able to drive the car home the remaining 20 minutes but there was some noticeable difficulty accelerating. When I went to turn on the car later that day the engine would not turn over and there was an audible rattling/chugging sound and the car itself shook. I was unable to get the car to start and the check engine light remained on. I had AAA check the battery the next day and confirm it was not a battery issue and a diagnostic revealed the P0192 code. AAA towed it to their shop where it was confirmed by the manager mechanic that the issue was with the high pressure fuel pump and that it was causing an issue with the low pressure fuel sensor as well. The mechanic was unable to determine what caused the pump to fail and has quoted me nearly $2000 to fix it. After some searching online it has become clear that this is an issue many other Mazda owners have faced and that is even a recall for the pump for years and makes from Mazda due to a known issue with DENSO fuel pumps causing this exact issue. Despite this being known and DENSO having admitted issue with fuel pumps in cars dating back to 2013, Mazda has not recalled the vast majority of the cars that could be affected. From information I've gathered, it is entirely possible that my vehicle could have just stopped running in the middle of the freeway due to this issue which obviously would have put me in great danger of an accident. To summarize: Low pressure fuel sensor and high pressure fuel pump with error code P0192 are cited as the issues. It's possible this issue can cause the car to stop running with no warning, which would be extremely dangerous especially on the freeway. The problem has been reproduced and confirmed by a AAA mechanic shop. The vehicle has been inspected by the AAA mechanic but no others. The check engine light came on but was not clear how extreme the circumstance was.