MAZDA Complaints

I looked up recalls on my vehicle and it states that The 2011 Mazda6 is  part of a recall (NHTSA 19V-323, Mazda 2818I) covering 2011-2013 models for front cross member (subframe) corrosion due to insufficient rust protection . In salt-belt states, this corrosion can cause the lower control arm to detach, reducing steering control and increasing crash risk.  Key Details regarding the 2011 Mazda6 Subframe Recall: Scope: The recall affects specific 2011-2013 Mazda6 vehicles (and 2009-2010 models in a previous, related recall). Location Restrictions: Vehicles must have been originally sold in, or currently/previously registered in, 23 "salt belt" states (including CT, NY, MI, MN, OH, etc.). The Issue: The front cross member may experience severe corrosion, causing structural failure of the passenger-side lower control arm mounting point. Symptoms: Drivers may notice a change in steering alignment or a broken cross member. Remedy: Dealers will inspect the cross member and replace it if necessary. Action Required: Owners should contact their local Mazda dealership to check their VIN for open recalls.  The recall was officially announced in May 2019 and is an expansion of a 2018 action. 

The contact owns a 2025 Mazda CX-30. The contact stated that while driving at approximately 2 mph into his garage, his right foot had slipped between the brake pedal and the accelerator pedal, and he was unable to get his foot out from under the pedals. The contact stated that the front end of his vehicle crashed into his garage wall. The contact stated that there was some damage to the front grill and the hood of the vehicle. The contact stated that he had not taken the vehicle to a dealer or collision shop. The contact had called the manufacturer and was advised that there was no action that could be taken to adjust the distance separating the brake pedal from the accelerator pedal. The contact stated that his foot had been trapped on two other occasions. The failure mileage was approximately 700.

I had both the left front and right front CV axles fail. My car only has 11.5k miles on. I first heard the clunking noise at 11k miles, went right to the dealer and had them watch me recreate the noise and they determined the axles needed to be replaced. This is incredible dangerous as the CV axle could have been completely disconnected from the wheel assembly leaving my car useless and uncontrollable.

When traveling down a road normally, the steering becomes suddenly harder to manipulate. It has a sticky feel when trying to turn normally. This has caused occasions where the car veers out of lane temporarily due to not responding to steering inputs normally.

When driving the vehicle and going into a sweeping turn on the road at highway speeds, mostly while turning into a left sweeping turn, the steering wheel will "jerk", and on a few occasions felt as if it was "stuck" and then would "snap" loose and allow the wheel to come back to center when coming out of the turn. I mentioned it to the dealer as there seems to be a growing number of people experiencing the same issues with the Mazda CX-90's in the 2024 year, but they said they couldn't reproduce it, but it happened to me again just driving away from the dealership. I tried to write it off as it was just my imagination, but I they also only had the vehicle for 15 minutes before they reported to me that they could not reproduce. This is happening after the initial recall for the steering was performed by Mazda on the vehicle. Safety would be at risk if for some reason the steering complete locks up at highway speeds, but any resistance in the steering wheel at driving is not a safe issue. No warning lamps or messages appeared on the vehicle.

Steering wheel gets "sticky" and "clunky" when turning the wheel while at speed. Anytime I turn a corner or accelerate into a turn the steering wheel feels like it locks up and clicks back to center - almost like negative feedback.

The steering wheel sticks especially when making long turns. It jutters and scares the driver. Some times it holds in place and you have to jerk it back to straight.

Repeated episodes of “sticky” steering. Requires a lot of effort or force to move the wheel. Highly problematic in turns. Have had to yank the wheel so hard to straighten it, it caused the entire car swerve. Very dangerous. After research, appears this is a wide spread issue with this particular vehicle.

I'd like to join the open investigation for RQ26002 [XXX] ). Our car has had jerky steering when doing a long turn at the same angle for well over a year. We brought in the car multiple times to the Mazda dealership and they said they couldn't find an issue, essentially ignoring our request. It makes the car unsafe to drive on the highway (and other roads) because the steering wheel jerks when it needs to straighten out after a curve. Please feel free to contact us with any additional questoins. Thank you. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Reporting multiple safety-related defects on my 2024 Mazda CX-90. Steering system: At approximately 5,000 miles, the vehicle developed abnormal steering behavior, including inconsistent steering response and abnormal feel during normal driving and turning. The condition affected my ability to steer the vehicle predictably and raised safety concerns, particularly during low-speed turns, parking maneuvers, and city driving. The issue was confirmed by the dealer and required replacement of the steering rack, a major steering component. The vehicle remains available for inspection upon request. Hybrid system: At approximately 22,000 miles, the vehicle experienced a hybrid system malfunction that required the vehicle to be taken out of service for an extended period. The malfunction affected drivability and reliability and required dealer diagnosis and repair. The vehicle was inspected and repaired by an authorized Mazda dealer. Braking system: The vehicle has experienced ongoing abnormal brake squeaking during normal driving and low-speed braking. While braking function remains present, the abnormal noise raises concerns about brake system integrity, wear, and long-term braking performance. Electrical / infotainment system: The infotainment system intermittently shuts off or resets while driving without warning. When this occurs, the display goes blank and then restarts. This results in loss of access to navigation, rear camera display, vehicle settings, and driver-assistance information, creating driver distraction and a potential safety risk. These issues occurred on a relatively new vehicle and involve critical systems including steering, drivetrain/hybrid, brakes, and vehicle electronics. The combination of defects raises concerns about vehicle safety, reliability, and loss of driver confidence. Warning messages were present for the hybrid malfunction; other issues occurred without warning. The vehicle has been inspected and repaired by authorized Mazda deal