2009 MERCURY MILAN Complaints

COMPLETE PRESSURE LOSS ON BRAKES AND PEDAL GOES ALL THE WAY TO THE FLOOR. CAR WON'T STOP PROPERLY.

TL* THE CONTACT OWNS A 2009 MERCURY MILAN. THE CONTACT STATED THAT THE VEHICLE WOULD NOT DECELERATE WHEN THE BRAKE PEDAL WAS DEPRESSED TO THE FLOORBOARD. THE DEALER DIAGNOSED THAT THE BRAKE MASTER CYLINDER NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIRED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 18,242. UPDATED 05/19/17*LJ *CN

DATE: 1/25/17 TIME: 5:45PM TEMP: 65F PRECIP: 0% WIND: 6MPH S PRESSURE: 1014MB HUMIDITY: 25% DEW PT: 28 UV INDEX: 0 VISIBILITY: -- MI APPROXIMATE MILES: 118K I WAS DRIVING THE VEHICLE NORMALLY AT APPROXIMATELY 25-30MPH APPROACHING AN INTERSECTION TO TURN INTO RESIDENTIAL/BUSINESS AREA. THE VEHICLE RODE OVER A SMALL AMOUNT OF LOSE ASPHALT OR GRAVEL, TO WHICH THE ABS UNEXPECTEDLY ENGAGED, IMMEDIATELY CAUSING THE BRAKE PEDAL TO "GO SOFT" WITH AN AUDIBLE NOISE (THE ABS ENGAGEMENT??). VEHICLE CONTINUED INTO INTERSECTION BUT AVOIDED COLLISION. VEHICLE CAME TO STOP MUCH FURTHER INTO INTERSECTION. AFTERWARDS, THE BRAKE PEDAL REMAINED (AND CONTINUES TO REMAIN) SUBSTANTIALLY SOFT, CAUSING THE DRIVER TO PRESS MUCH FURTHER. THIS IS EXTREMELY DANGEROUS BECAUSE SUDDENLY, BRAKING NO LONGER WORKS AS ACCUSTOMED TO. *TR

FOLLOWING AN ABS INCIDENT, THE BRAKE PEDAL IS SOFT AND GOES TO THE FLOOR. PUMPING THE BRAKE PEDAL DOES NOT RESOLVE THE ISSUE. I AM CONCERNED THE BRAKE SYSTEM WILL CEASE TO FUNCTION.

TL* TAKATA RECALL. THE CONTACT OWNS A 2009 MERCURY MILAN. THE CONTACT RECEIVED NOTIFICATION OF NHTSA CAMPAIGN NUMBER: 16V384000 (AIR BAGS); HOWEVER, THE PART TO DO THE REPAIR WAS UNAVAILABLE. THE CONTACT STATED THAT THE MANUFACTURER EXCEEDED A REASONABLE AMOUNT OF TIME FOR THE RECALL REPAIR. THE MANUFACTURER WAS MADE AWARE OF THE ISSUE. THE CONTACT HAD NOT EXPERIENCED A FAILURE. VIN TOOL CONFIRMS PARTS NOT AVAILABLE.

TL* THE CONTACT OWNS A 2009 MERCURY MILAN. THE CONTACT STATED THAT WHEN ATTEMPTING TO STOP THE VEHICLE, THE BRAKE PEDAL WENT TO THE FLOORBOARD. THE FAILURE OCCURRED WITHOUT WARNING. THE FAILURE OCCURRED ON FOUR OCCASIONS. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE CONTACT MENTIONED THAT THE BRAKE FLUID WAS REPLACED AND THE VEHICLE WAS REMEDIED. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS APPROXIMATELY 45,000.

I PUT IN A PREVIOUS COMPLAINT ABOUT SOFT BRAKES AND NOW AM HAVING THE ISSUE AGAIN. LAST NIGHT A CAR CUT ME OFF AND SO I HAD TO APPLY THE BRAKES HARD AND AFTER THAT THE BRAKE PEDALS WENT SOFT AND HAD TO BE PRESSED ALL THE WAY TO THE FLOOR. TODAY THE BRAKES ARE STILL THE SAME AND MAKE BRAKING VERY DIFFICULT. *TR

I WAS DRIVING ON A ROAD WHEN I STRUCK A BUMP AND MY BRAKES WENT SIMULTANEOUSLY, THIS WAS 3WEEKS AGO SO I DIDN'T THINK ANYTHING OF IT OTHER THAN I MAY NEED SOME BRAKES. I GOT MY BRAKES DONE TODAY BUT I STILL HAVE THIS SAME PROBLEM WITH THE PEDAL GOING TO THE FLOOR. WHICH PROMPTED ME TO GO ONLINE TO INVESTIGATE FURTHER. *TR

THE CAR WAS IN MOTION AND AS WE TRIED TO STOP THE BRAKES HAD TO BE PUSHED ALL THE WAY TO THE FLOOR TO STOP. THIS WAS IN WET WEATHER BUT IT HAPPENED ALL THE WAY FOR 30 MINUTES ON THE HIGHWAY ON THE WAY TO WORK, AND 5 MINUTES THE NIGHT BEFORE ON SIDE STREETS. THIS WAS NOT BECAUSE OF ICY ROADS. ON THE WAY HOME IT WAS FINE. NO ANTILOCK BRAKE LIGHTS OR STOPPING MECHANISM CAME ON. THE BRAKES SEEM TO RANDOMLY ADJUST AS TO HOW MUCH PRESSURE IS APPLIED. BRAKES ALSO SQUEEK WHEN BACKING OUT. THIS HAS BEEN LOOKED AT SEVERAL TIMES WITH NO RESOLUTION.

MY BRAKES LOSE PRESSURE IF I HIT A BUMP WHEN BRAKING OR IF I SLIDE ON SOMETHING WHILE BRAKING. AFTER THE BRAKES LOSE PRESSURE I HAVE TO PUMP THEY BRAKES UNTIL THE PRESSURE BUILDS BACK UP WHICH USUALLY TAKES A DAY OR SO. TODAY I SLID IN THE SNOW AND COULDN'T STOP AND SLID INTO ONCOMING TRAFFIC, LUCKILY I WAS ABLE TO CORRECT AND AVOID A CRASH BUT NOT THERE IS MINIMAL PRESSURE IN MY BRAKES WHICH MAKES IT DIFFICULT TO JUDGE STOPPING THE SNOW WHILE PUMPING BRAKES. PREVIOUSLY THIS HAS HAPPENED WHEN WAS STOPPING AND HIT A PIECE OF CARDBOARD ON THE PAVEMENT AND COULDN'T STOP AND WENT INTO THE INTERSECTION. I HAVE TO MAKE SURE I DON'T BRAKE ON BRIDGES WHERE THE BRIDGE CONNECTORS ARE BECAUSE THIS ALSO CAUSES THE BRAKES TO LOSE PRESSURE. THE ONLY TIME THE BRAKES LOSE PRESSURE IS IF I AM BRAKING WHEN I HIT A BUMP OR SOMETHING THAT MAKES ME SLIDE. THIS HAS BEEN GOING ON FOR ABOUT A YEAR BUT I DIDN'T KNOW HOW TO FILE A COMPLAINT UNTIL I SAW THE ARTICLE LAST WEEK, TODAY IT ACTUALLY HAPPENED AGAIN SO I AM DATING THIS TODAY.