2013 MITSUBISHI OUTLANDER SPORT Complaints

The contact owns a 2013 Mitsubishi Outlander Sport. The vehicle was taken to the local dealer to be repaired under NHTSA Campaign Number: 21V144000 (Suspension, Structure); and it was determined the undercarriage was extremely rusted. The vehicle was not repaired due to the rust. The manufacturer was contacted, but no additional assistance was provided. The failure mileage was approximately 100,000. Parts distribution disconnect.

The lights on my clutch are not coming on. I’m concerned there are other electrical issues affecting the cluster and the odometer display

AIRBAG SYSTEM SERVICE REQUIRED message appears on dash. Occurred on 09/20/2018 and again on 09/29/2023. Both times required service to fix. Has now happened again on 10/14/2024. Secondary issue was reported by another driver for same vehicle for NHTSA ID Number: 11339357 and NHTSA ID Number: 11567379

In 2020 I got a recall for engine support from Mitsubishi. We took it in and told me that the support was find that I didn’t need to be replace even tho the recall called for it. They ended up putting rust paint on the support. 4 weeks ago that part broke on my wife when she was driving down the road. The steering wheel was taken out of my wife’s hand while driving. She was able to get the off the road safely. But sprained her wrist. When I found the broken part on the car. I call Mitsubishi themself. When I reported these issue, I was told that someone would be coming to my house to look at the car. I signed a form for them to do that. And for the to read the computer on my car. That was 4 weeks ago. I have emailed them and called them. And no one knows what I’m talking about our replying to my email. And on top of it all we are missing work, at least one day a week because of this.

My electrical system and/or computer brain is not operating properly. About a year and 1/2 ago the low beam passenger light stopped working. I had the bulb replaced at Walmart. 2 months later it went out again. Walmart checked and said the bulb was not the problem so I went to Firestone and was told the wiring was melted. Firestone said my options were to replace the entire harness or pig tail the low beam. I opted for the pig tail. A few months later I had issues with slow starts as if my battery was being drained. A few weeks after that my drivers side low beam started working intermittently. Then went out completely. I went to Gillman dealership in Schertz, TX (330 miles from my home) who said the bulb needed to be replaced which they did. A month later the drivers low beam is out again. Firestone says the wiring has melted on that side too. This time I asked them not to fix it because I wanted to go back to the dealership to repair. 1 week later my battery died twice and the passenger low beam has stopped working again. A mechanic advised that a few years ago he worked on a 2012 Mitsubishi with the same issues and ended up totaling it out because the car’s computer was not modulating voltage properly. He said that car’s computer was not reading the codes correctly and was outputting voltages that did not match the Outlanders configuration. I was told there is a recall for this already. I wanted information on this before contacting the Texas State Attorney General’s Consumer Protection Office.

hello: i purchased this vehicle last nov. the rear hatch was opening fine," but after a couple of months it has stopped and the only way to open it," is from the lever on the inside. you have to use a screw driver or prying tool of some sort to remove the cover in order to get to the lever and you have to lay the back seats down and crawl back there to get to this. i've spoken to other owners who have the same issue. they've had to replace either and or both the actuator and the handle tailgate lock release mechanism. the handle tailgate lock release mechanism is electrical and is susceptible to water getting into it and corrodes the electrical parts. it sits mostly flush one the outside of the hatch where water can get too it. i feel this is a safety issue incase of an accident or emergency if it is imperative to gain access. also the design of the so called emergency release lever is terrible. some people might not have a screw driver or something to pry with in order to remove the cover in order to gain access to the release lever. in my opinion (1)the emergency lever needs to be redisgned and have easier access to it.(2) replace the acutator and or the handle tailgate lock release. it could cost owners up tp $400 to replace these item at a dealership," unless they would want to tackle it themselves. i feel it's worth looking into. thankyou for your time and any help.

The contact owns a 2013 Mitsubishi Outlander Sport. The contact stated that while driving at various speeds, his wife indicated that the vehicle was not driving in a straight line. Upon inspection, it was discovered that the front driver’s side suspension lower control arm had fractured due to subframe rust and corrosion. The local dealer and manufacturer were notified of the failure, but no assistance was offered. The vehicle was not yet repaired. The contact stated that the vehicle was previously serviced under the NHTSA Campaign Number: 20V279000 (Suspension) but the failure occurred. The failure mileage was 140,000. The contact stated that the subframe was repaired two years ago under recall but there is rust and corrosion again.

Airbag service system light is on In my car and the codes ran and it popped up SR-14-001 they gave me paperwork saying its a recall on my driver seat mounted airbag wiring has been improperly installed. Dealership is saying its not a recall.

The contact owns a 2013 Mitsubishi Outlander Sport. The contact stated while driving at various speeds, the "Transmission Overheating" message was displayed on the instrument panel as the vehicle lost motive power. The contact stated that the vehicle would restart after waiting approximately 10 minutes and would resume normal operation. The contact had taken the vehicle to an independent mechanic who discovered that there was no defect with her vehicle and that the failure was linked to an electrical issue. The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 52,000.

The contact owns a 2013 Mitsubishi Outlander Sport. The contact stated while driving 65 MPH, the transmission started overheating. There was a message displayed on the instrument panel to Slow Down. The vehicle then started to decelerate independently. The contact was able to park the vehicle and waited 10-15 minutes before restarting the vehicle. The contact stated that failure recurred within 45 minutes. The contact took the vehicle to an independent mechanic and was informed that the pin needed to be replaced. The vehicle was not repaired. The contact took the vehicle to another independent mechanic where the mechanic performed a transmission flush. The contact continued to experience failure after the transmission was flushed. The vehicle was not diagnosed or repaired. A dealer was not contacted. The manufacturer had not been informed of the failure. The failure mileage was 96,793.