2018 RAM 1500 Complaints

On Arpril 4 2025, after dropping off my kids at daycare I was turning left at a 6 lane intersection and the power steering completely failed while turning. This rendered the truck inoperable and nearly caused a collision and stopped right before ending in a ditch. I turned the truck off and then restarted and the power steering started to operate again. I took the truck to the shop and in route the power steering went out again. I was told at the shop and the dealership this is a known concern, but due to my VIN number it does not fall under the recall that has been issued over the power steering failures. I was never notified of this issue prior to 4/4/2025 .

while driving the power steering indicator light came on, after 1 mile the power steering stopped working.

The contact owns a 2018 Ram 1500. The contact received notifications of NHTSA Campaign Numbers: 22V406000 (FUEL SYSTEM, DIESEL) and 23V411000 (ENGINE AND ENGINE COOLING); however, the parts to do the recall repairs were not yet available. The local dealer was contacted. The contact stated that while driving at an undisclosed speed, the vehicle failed to accelerate as intended while depressing the accelerator pedal. The vehicle hesitated before functioning normally. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was unknown. Parts distribution disconnect.

The abs keeps randomly disabling and then coming back on. When this happens, the cruise control is canceled which causes a sudden change in speed unexpectedly. Also, the 4x4 gets disabled. I believe the issue is this: hydraulic control unit can malfunction, impacting ABS, electronic stability control, and traction control performance software issue in the Anti-lock Brake System (ABS) control module that can disable the Electronic Stability Control (ESC) system, potentially increasing the risk of a crash. 

The contact owns a 2018 RAM 1500. The contact stated that while driving at an undisclosed speed, the vehicle stalled and lost motive power. The throttle control warning light was illuminated. The vehicle was towed to an independent mechanic where it was diagnosed with fuel pump failure. The contact was informed that the fuel pump needed to be replaced. The vehicle was not repaired. The vehicle was towed to the dealer and was diagnosed with fuel pump failure. The contact was informed that the fuel pump needed to be replaced. The vehicle was not repaired. The contact was informed that the parts were on backorder. The contact received notification of NHTSA Campaign Number: 22V406000 (Fuel System, Diesel); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure and a case was filed. The contact was advised to contact the NHTSA Hotline to report the failure. The failure mileage was 82,000. Parts distribution disconnect.

The engine seized up at 52,517 miles on February 28, 2025. It was making loud noises on the freeway and was losing significant power. We exited the freeway trying to get to a safe location and the engine froze. I had the engine replaced and the check engine light came on after 40 miles!

While being driven, the ecodiesel engine had a faulty ball bearing that malfunctioned inside the engine. This ball bearing then shot through the middle of the engine and out the bottom of the engine. The service technician at our local dealership inspected the engine and compared this to a "bullet under too much pressure due to a fault within the engine." He then said we "were lucky the ball bearing hadn't shot upwards through the floorboards." Not only could we have been at risk, other passing vehicles could have been shot with the ball bearing; this event could have led to wrecks and possible fatalities. The engine was completely destroyed by this defective ball bearing and cannot be rebuilt. No lights or messages appeared after the ball bearing shot through, even though the oil began draining instantly. The truck was pulled over and turned off before all the oil drained to prevent damage to the engine, which was already destroyed without us knowing.

This is my 2nd complaint...Uconnect never did return my call as they promised they would....now our Uconnect is so bad it makes driving a safety concern. After starting our Ram the Uconnect keeps trying to call a number ....we have no idea what number it is but it continues dialing....we can not turn it off so if we need to drive this vehicle this is what we have to put up with....very distracting...I see many complaints on this website but nothing is being done....we get nowhere with Uconnect even though we have called numerous times...we can not access any of the features from this radio/Uconnect device...cameras...non functioning on the screen....what will it take before someone does something to make the manufactures respond.....as long as NHTSA does nothing....then Uconnect will feel embolden to also do nothing....PLEASE THIS NEEDS TO BE ADDRESSED ..

The contact owns a 2018 Ram 1500. The contact stated that while driving at various speeds, there was an abnormal ticking sound coming from the vehicle. There was no warning light illuminated. The vehicle was taken to two separate independent mechanics who both stated that the exhaust manifold was warped due to a fractured bolt. The contact was informed that the exhaust manifold needed to be replaced. The manufacturer was notified of the failure and was informed that there were no recalls on the vehicle. The vehicle was not repaired. The failure mileage was approximately 77,000.

my 2018 Ram Limited 1500 ABS control Module has FAILED at 72045 miles; Dealer tried to order new one and dealer told me that NONE are available and he was told to call back March 20 and they would let him know if any available; Dealer was unable to get a new ABS module AND dealer was not able to put me on a list when new and IF new module comes available; This is a very UNSAFE condition in rainey Houston Tx; I went to brake servicer and he ordered me a remanufactured module; Brake company was unable to install remanufactured because it would NOT accept my VIN during programming;; I think all Ram's need to have a SAFETY recall on this Abs MODULE Problem ! I noticed the ABS module has been recalled on the deisal RAM's