2018 RAM 1500 Complaints

Failure of the ABS control module. Scanning of the trouble code shows internal electronic failure code C2200-49. Loss of ABS on vehicle, decreased stability on wet surfaces. Appears to be a known issue with Rams, my vehicle is not on the recall list for this issue but should be there should be a wider recall forced on Ram for this issue. Loss of ABS and traction control, Loss of cruise control, and increased risk of transmission damage that may result in loss of drive at wheels during operation that may result in an accident.

My ABS is not working due to a faulty ABS module or hydraulic control unit this has caused my truck to lock up the brakes during a hard stop instead of the ABS working it also has affected the cruise control. It no longer works. This is not an issue just with the 2500,3500 let’s get 1500 on board.

Electronic power steering has started working intermittently. Very hard to steer truck at times. Very dangerous.

All of a sudden while driving or idling engine will complete shut itself off. Rpm to 0 and if driving truck has shift to park to start. Once shifter to park and restarting car truck will start right back up however this issue has been ongoing and Dodge/ram has been no help with a solution. Brought it to an outside mechanic and after having a ton checked either pointing to a faulty PCM or TIPM module. Recent discovery is the tipm also know as the main fuse box under the hood is overheating - causing the truck to stall out

while driving down the highway at 50-70 mph, when attempting to pass I give it more gas and I hear a clunk with the loss off power!, I have to allow to slow down then slowly increase speed! I have my second factory installed transmission @ 40,000 miles!

The contact owns a 2018 Ram 1500. The contact stated that upon starting the vehicle, the “Service Air Bag” message was displayed on the instrument panel. The air bag warning light remained illuminated while driving. Additionally, the horn was inoperable while depressed, and the controls on the left side of the steering wheel failed to operate as intended; however, the right side of the steering wheel operated as intended. The dealer was contacted for recall information and informed that the vehicle was not included in a recall. The vehicle was not diagnosed or repaired. The failure was associated with an unknown recall found online. The manufacturer was not notified of the failure. The approximate failure mileage was 120,000.

My vehicle was involved in the Z46 High Pressure Fuel Pump recall. I recently had multiple error codes: P1290, P0087, P1292, P1290. I delivered the truck to the dealer at the end of December and the truck has been grounded for 60 days waiting for the redesigned filter. The ETA for the part keeps changing.

UNKNOWN. 2018 RAM 1500 5.7 ABS CONTROL MODULE internal malfunction code C2200-49. A known malfunction in many ram 1500. Already recalled in RAM 2500 to 5500. Part is on Back order with no known eta. Why is the 1500 excluded from the recall...

The contact owns a 2018 Ram 1500. The contact stated that while reversing, the back-over prevention camera malfunctioned and the screen was blank, creating a rear visibility hazard for the driver. Additionally, while driving at an undisclosed speed, the vehicle stalled and was towed to the local mechanic. The alternator and battery were replaced on several occasions; however, the failure persisted. The contact stated that on another occasion, while driving at an undisclosed speed, the tailgate erroneously opened. The cause of the failures was not yet determined. The manufacturer was notified of the failures and informed the contact that the VIN was not included in NHTSA Campaign Numbers: 18V398000 (BACK OVER PREVENTION) or 19V347000 (LATCHES/LOCKS/LINKAGES). The contact stated that the vehicle had experienced the failures listed in the recalls. The failure mileage was unknown.

I wanna report a refuling issue with my vehicle. I have an issue with the gas pump clicking or turning off numerous times it started happening not to long after having the truck. I have to literally hold the pump with my hand to refuel my it. If I don't do this the tank will never get filled. I also have to watch closely so the gas doesn't overflow and pour out on my truck to the ground. This has happened in the past very dangerous and wasteful with gas coming out like that. I have read different fixes for the problem but no help from Dodge about it as apparently no recalls about this issue. Which it looks like I'm going to have to try and get it fixed out of my own pocket. It's a struggle everytime time to fuel it up. I think Dodge should fix this especially since it's already known about by them.