2014 RAM 2500 Complaints

The contact owns a 2014 Ram 2500. The contact stated that while driving on several occasions at various speeds, the instrument panel failed to display pertinent information. The vehicle was not diagnosed or repaired. The contact believed that the failure was associated with NHTSA Campaign Number: 13V486000 (Electrical System). The manufacturer was not notified of the failure. The failure mileage was approximately 189,000.

Drag link recall for my 2014 Ram 2500 was performed in 2019 and failed in 2024 causing the steering component to became loose while driving. When I had it "re-fixed" by Folsom Lake Dodge and Chrysler dealership they re-welded it without aligning the steering column so my steering wheel has been off ever since(not centered). This needs to be fixed not band aided.

On 5/28/2019 Recall V06 was completed on my 2014 Dodge Ram 2500. As part of that repair the adjustment nuts on the steering drag link were welded to prevent loosening and potential separation. On 3/3/2026 I had new front suspension components installed by Les Schwab Tire Center. During that service the technician advised a wheel alignment could not be performed because the welded drag link nuts prevented the steering linkage from being adjusted. Alignment is normally required after front suspension work and necessary for proper steering geometry. Les Schwab advised that grinding the welds off the drag link to perform the alignment and then rewelding the component would be unsafe because it could introduce hidden stress or cracking in the steering component. They recommended replacing the drag link with a Moog DS801538A redesigned component. The drag link had to be replaced to restore normal steering adjustment and allow the vehicle to be properly aligned. On 3/3/2026 I requested reimbursement from Dodge/Chrysler for the drag link replacement required due to the recall repair. The request was denied. On 3/4/2026 Chrysler representatives acknowledged the welded drag link rendered the vehicle unserviceable for alignment yet still denied reimbursement. Chrysler’s Vehicle Alignment Clarification Letter states that after the recall repair, owners should still be able to obtain an alignment using an approved procedure. In my case, however, the welded drag link prevented any adjustment necessary to perform that procedure, making the vehicle unserviceable for alignment until the drag link was replaced. The recall repair rendered a steering component non-adjustable and prevented normal service, leaving the vehicle less serviceable than before the recall repair. Documentation and photos are attached.

A red warning light appeared on my dash which says to” service airbags.” It has been on for a few months now. I’m really concerned now since I heard about airbags being recalled.

Check engine light came on end of November 2025 and stayed on. Immediately I took the truck to two different independent mechanics. They both said it was a problem with the turbocharger but I never received a recall regarding this. They both said I could still drive it and that it would not leave me stranded. The last recall done was the 67A a year ago. There are currently no recalls for my particular vehicle through the NHTSA. The truck is currently having the very expensive turbocharger replaced by one of the independent mechanics. Why wasn't I alerted to this problem?

The contact owns a 2014 Ram 2500. The contact stated that while driving at 65 MPH, the steering wheel shifted while turning. The contact self-diagnosed the vehicle and found that there was slack in the track bar and brackets that needed to be reinforced. The vehicle was not diagnosed or repaired by a dealer or independent mechanic. The manufacturer was notified of the failure. The failure mileage was approximately 175,000.

I took my 2014 Dodge Ram 2500 (VIN: [XXX] ) to Glendora Chrysler Dodge Jeep Ram on Lone Hill Ave. for Recall R46. The dealership kept my truck most of the day but did not perform the recall. Instead, they told me something untrue—that my upgraded suspension made the repair impossible—without ever attempting the repair. They then tried to pressure me into signing a waiver of liability stating the recall could not be performed and gave me the runaround when I refused. This dealership was unwilling to help me and misled me instead of completing a federally mandated safety recall. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Twice in the same manner my 2014 Ram has sucked the fan shroud through the radiator. When under load (towing under the weight maximum) and moving at highway speeds 60-70 MPH, the fan shroud softens to a point where it is pulled in by the fan and slung through the radiator causing debris and immediate leakage and power loss, effectively stopping the vehicle. This fault has occured twice the same way in the last two years and according to forums is a continuous problem with the trucks

The contact owns a 2014 Ram 2500. The contact stated that the area around the radio was overheating. The vehicle was taken to the dealer was unable to determine the cause of the failure, but the radio was replaced. The contact stated the area around the radio was still overheating even with the radio turned off. The contact believed that there was a possible electrical failure with the fuse lines inside the vehicle around the console. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was 45,000.

The TIPM is bad. Truck goes dead whenever it wants. I’ll be driving down the highway and it quits and then you can’t get it to start back. Windshield wipers work sometimes other times they randomly come on.