2013 TESLA MODEL S Complaints

The vehicle has suffered a catastrophic, intermittent low-voltage network crash caused by a failing Body Control Module (BCM), resulting in multiple dangerous safety-critical failure modes. On a previous occasion, the vehicle woke up with severe network faults and automatically forced itself into Neutral. When the driver stepped out to get the child and shut the door, the system crashed entirely and the exterior electronic door handles failed to present, trapping an infant child inside the running vehicle. Most recently, while driving in a rainstorm, the vehicle suffered a complete failure of the windshield wipers, a total loss of the high-beam headlights, a total loss of the horn, and a total loss of electronic communication to the electronic parking brake system. Most critically, the vehicle experienced an uncommanded propulsion hazard where it hard-locked itself in the 'Drive' gear and absolutely refused to shift into 'Park' or 'Neutral,' forcing the driver to physically maintain heavy hydraulic brake pressure to keep the vehicle from creeping forward. Because the horn failed and the parking brake was disabled, the driver was trapped in the driver's seat holding the brakes and was forced to call 911 for emergency first responders to come and physically block the wheels so the driver and infant could safely exit. Tesla Service has diagnosed the issue as a failed central Body Control Module (Part #1010906-00-D), but the cascading network failure modes present an extreme, life-threatening hazard regarding vehicle control and child entrapment.

This issue appears to be related to a known MCU failure affecting early Tesla Model S vehicles. The touchscreen exhibits screen melting/discoloration and eventually goes blank or becomes inoperative. When this occurs, critical functions including occupant detection indicators, seatbelt warnings, and windshield defrost controls may become unavailable. The loss of these functions creates potential safety risks involving visibility, occupant protection, and driver awareness while operating the vehicle."

This issue appears to be related to a known MCU failure affecting early Tesla Model S vehicles. The touchscreen exhibits screen melting/discoloration and eventually goes blank or becomes inoperative. When this occurs, critical functions including occupant detection indicators, seatbelt warnings, and windshield defrost controls may become unavailable. The loss of these functions creates potential safety risks involving visibility, occupant protection, and driver awareness while operating the vehicle."

While driving my 2013 Tesla Model S at normal road speed, the vehicle suddenly lost all propulsion without any warning. I had to coast and maneuver across traffic to avoid being hit before the car came to a stop. After shifting into Park, the vehicle displayed DI_w072 and DI_f072 gate-drive faults, which indicate inverter/drive-unit failure and match a pattern reported by other early-model-year Tesla owners. This sudden loss of motive power created a serious safety hazard, including risk of rear-end collision and exposure to oncoming traffic while disabled. • No alerts appeared before the failure • Fault codes appeared only after the vehicle stopped • Vehicle required towing • Incident occurred under normal driving conditions • Tesla has denied responsibility or involvement It was serviced by Tesla a couple days before. During servicing they stated on one side the drive axle was not completely installed upon arrival. They stated they "popped it in for free but the drive unit will likely need replacement soon." Prior to this visit i have had no issues or alerts with these parts or systems, I declined any work to these areas. The next day after receiving my vehicle back, I discovered the coolant reservoir was completely empty. No warning was provided that the coolant system had been left unfilled, and the lack of coolant may have contributed to thermal damage in the drive unit or inverter. They denied any work they did involve these parts and denied any responsibility. They denied my request to have the car towed to their service center and diagnose it unless i paid for it. They also estimated the repair to cost me 6k without any further investigation. I request that NHTSA evaluate whether this failure mode represents a broader defect affecting 2012–2015 Model S drive units/inverter electronics and whether further investigation or recall is warranted.

Vehicle lights turned off while driving home with my family. Pulling over and turning off and on the car reset the problem. When lights turned off I received a warning light identifying a faulty right headlight and faulty left headlight. No accident and vehicle is currently outside manufacture warranty.

The contact owns a 2013 Tesla Model S. The contact stated that the parking brake seized while leaving a charging station, and the vehicle screeched into oncoming traffic and stalled. The parking brake warning light was illuminated. The local dealer was contacted, and an appointment was scheduled. The vehicle had not been charged prior to a snowstorm, and the battery became fully drained. The vehicle was taken to the local dealer, where it was determined that the main battery and 12-Volt battery needed to be replaced before the diagnostic test. The vehicle was repaired, but the failure reoccurred. The vehicle failed to shift into drive or move. The jack mode was disengaged. While driving, the rear wheels were screeching. The contact stated that the failure was related to TSB: SB-21-33-002). The vehicle was towed to another local dealer, Tesla Service Arlington-Glebe Rd (2710 S Glebe Rd, Arlington, VA 22206). The vehicle was not diagnosed or repaired. The battery was at 19 percent. The manufacturer was contacted, but no additional assistance was provided. The failure mileage was approximately 108,000.

I have a 2013 Tesla Model-S, I have so far spent thousands on this car for door handle related problems over its lifetime. And Tesla still keeps charging for any door repairs. As of now, the driver side door doesn't open from outside and this is a serious safety hazard in case of an accident

On [XXX], at approximately [XXX], I was driving my 2013 Tesla Model S (VIN: [XXX] ) on [XXX] in Barrow County, Georgia when the instrument cluster/speedometer display went completely blank while driving. This is an intermittent issue that occurs without warning - the display turns off and sometimes freezes. Because the speedometer was not displaying, I had no way to know my actual speed. I was pulled over by Barrow County Sheriff’s Office and cited for speeding. I explained the instrument cluster malfunction to the officer at the scene and showed him the blank display. I took my vehicle to Tesla Service Center in Duluth, GA (3380 Satellite Blvd) on November 4, 2025 - as soon as I could get an appointment after the incident. Tesla cleared the filesystem caches but did NOT inform me about the existing eMMC recall (SB-21-21-001) that affects my vehicle, nor did they perform the recall repair. My 2013 Model S is equipped with the MCU1 with the 8GB eMMC that is subject to NHTSA Recall 21V-119. This is a known defect that NHTSA determined to be a safety issue because it affects critical displays including the speedometer, backup camera, and turn signal indicators. I have video evidence of the malfunction occurring and the Tesla service receipt documenting the issue. The fact that Tesla’s service center did not notify me of the applicable recall or perform the free recall repair. This defect directly resulted in me receiving a traffic citation because I could not see my speedometer while driving INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

While charging my 2013 Tesla Model S, the vehicle experienced a charging system failure and would no longer charge. Upon inspection, I discovered water intrusion and corrosion on the lower portion of the charging-related electronic circuit board at the bottom of the charging port and right where the High Voltage cables are located as well. The affected electronics are located in an area that is not normally exposed to water and is not owner-serviceable. Later model Tesla Model S vehicles (2014 and newer) include a drain in this exact location, which this vehicle does not have. This design change appears to directly address the same water accumulation issue that caused the failure in my vehicle. The failure results in loss of the vehicle’s ability to charge, rendering the vehicle inoperable. Tesla declined to repair the issue, stating the vehicle is out of warranty, despite acknowledging the design change in later models. This appears to be a latent design issue related to water ingress into critical charging electronics, which presents a safety and reliability concern due to loss of propulsion capability and water exposure to High Voltage parts.

The screen abruptly shuts down and that is a safety hazard. Tesla has refused to fix this issue.