2010 TOYOTA PRIUS Complaints

The contact owns a 2010 Toyota Prius. The contact stated that while driving at 55 MPH, with the brake pedal was depressed and went to the floorboard. The contact stated that the brakes failed to adequately slow the vehicle. The ABS warning light was illuminated. The vehicle was taken to an independent mechanic, who diagnosed a failure with the brake booster. The vehicle was not repaired. After investigating the failure, the contact related the failure to NHTSA Campaign Number: 13V235000 (Service Brakes) however, the VIN was not included. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the NHTSA Hotline for assistance. The failure mileage was 120,000.

My car accelerated significantly on its own while I was pulling into a parking stall in a private parking lot. It caused my vehicle to jump a curb and accelerate up a dirt divider and push over a bush that was planted in the dirt divider. Depressing my brakes did not Decelerate the car, so I pressed the Park button to eventually stop the vehicle. I’m not sure what speed it was traveling when it accelerated, but I could smell burning rubber at the end of the incident. I’m not sure when the smell first occurred.

Brake booster assembly failure. Code C1391 - accumulator pressure leak. Toyota previously agreed to extend the warranty on this part on this year of Toyota Prius due to the known issue and the time limit for this repair was set to be in 2019. Toyota agreed to replace the unit only if it fails before that timeframe. My Toyota got recently affected by this issue resulting in over $3,000 estimate for a repair as Toyota no longer covers this repair for my vehicle. That’s a known issue with this part, Toyota knows it’s faulty and yet no recall has been issued. Now I have to pay for a repair out of pocket. I can’t drive the vehicle until it’s fixed. This should be handled as a recall with all faulty units being replaced regardless of millage. A few people opened lawsuits on this issue before and some got a settlement. I believe there is enough evidence that this should be classified as a recall and a free of charge repair should be provided to the owners. The brake booster unit has been buzzing a lot for quite a few months ( due to the pressure leak it had to work more than normal). Now it completely failed with the leak being so excessive that the brakes are very soft.

The contact owns a 2010 Toyota Prius. The contact stated that while driving at an undisclosed speed, the vehicle stalled. The check engine warning light and the check hybrid warning light illuminated. The vehicle was taken to the dealer. The contact was unaware whether the vehicle was diagnosed. The vehicle was repaired under NHTSA Campaign Number: 18V684000 (Hybrid Propulsion System). The contact stated that after the vehicle was repaired the failure recurred. The contact stated that the vehicle had not been repaired as the recall repair stated. The manufacturer was made aware of the failure but offered no assistance. The failure mileage was approximately 152,000.

I had begun to notice a slight shimmy at highway speed for a few days, but it wasn't pronounced enough to cause concern, especially since the weather was very windy and already subjecting the car to heavy crosswinds. On Monday, [XXX], the shimmy became suddenly more pronounced, so I pulled off the highway ([XXX]) and parallel-parked on street in Cambridge, MA. While parking, I heard a loud creaking and grinding sound, and the car no longer responded to steering inputs. I exited the car and noticed the rear driver's side wheel protruding at a strange angle from the wheel well. I called AAA and the tow truck driver discovered that, behind the wheel, where the wheel meets the rear axle, the arm had rusted clean through. In other words, the wheel had completely fallen off, and was being held to the car only by the brake line. I was towed to a mechanic in Salem, MA. Both the Salem mechanic and the AAA tow truck driver said that they had never seen anything like this in all the years they'd been servicing cars. I told them that the car had never been in a flood or otherwise involved in the kind of extraordinary event that would cause more than typical rust exposure. Had the wheel come off at highway speed, I could have been seriously injured or killed. The issue did not seem to have been caused by driver/owner oversight or normal wear and tear. It seems highly unusual and potentially indicative of a defect or manufacturing error. I hope other 2010 Prius owners are aware of the vehicle's susceptibility to this issue. And I would like Toyota to take some responsibility for the high cost of repair. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I’m encountering multiple dash lights with the brakes being very unreliable and no that’s no regenerative breaking. I checked with an obd2 kit and the app shows that I have a code C1391.

Faulty brake boosters that crack and leak, making brakes unusable and draining the battery (diagnostic code C1391). There was a Toyota service repair where they exchanged the faulty brake boosters with properly working ones, but it has lapsed.

see all over the internet that 2010 Prius have a recall for Inverter. I called the dealer they said no recall with my vin. I was told that a new inver is almost $5000 dollars. i NEED HELP i HAVE BOUGHT 3 TOYOTA ALREADY. Please help me with good will or warrenty the inverter like you have so many other people with 2010 Prius. If not I willand my family will never buy a Toyota again. Please call or email me [XXX] [XXX] The Prius died when driving and we almost got in a major accident because it stalled with no warning. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2010 Toyota Prius. The contact stated that while driving at an undisclosed speed and attempting to slow the vehicle, he became aware that the brake pedal required excessive force to bring the vehicle to a complete stop. The service brake warning light was illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the brake booster and brake master cylinder. The vehicle was not repaired. The vehicle was then taken to an independent mechanic, who confirmed the diagnosis and additionally found that there was a leak in the brake fluid accumulator, resulting in low brake fluid pressure. The vehicle was taken back to the dealer, who added brake fluid to the braking system, which seemed to temporarily resolve the failure. The manufacturer was not notified of the failure. The failure mileage was 140,000.

Total malfunction at highway speeds. Very unsafe, the car completely shut off. This may have resulted in a highway fatality due to collision as the vehicle was in the fast lane. NTSA please do your due diligence and investigate the faulty, defective HYBRID system as I believe the faulty inverter recall is much more larger than the original recall