2011 TOYOTA TACOMA Complaints

I purchased a vehicle from a car dealer "as is" with a clean title. About two months after purchase I took it to a mechanic after I got an airbag light and he told me the vehicle was missing airbags and was in a hard enough collision that it caused the airbags to deploy. This was not listed on the Carfax report and was not disclosed to me. I would have never purchased a vehicle if I knew it was missing airbags.

The contact owns a 2011 Toyota Tacoma. While inspecting underneath the vehicle, the contact discovered that the vehicle was only equipped with three leaf springs instead of four. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was made aware of the failure and informed the contact that there was no recall for the failure associated with the VIN. The failure mileage was unknown.

The contact owns a 2011 Toyota Tacoma. The contact stated that over time the horn intermittently became inoperable; however, the horn operated while in the middle of making a turn. The contact was concerned about the failure because the horn and the air bag in the steering wheel were connected by the clockspring. No warning lights were illuminated. The local dealer was contacted; however, the vehicle was not diagnosed or repaired because the VIN was not associated with a recall related to the failure. The local dealer confirmed that the VIN was not included in a recall related to the failure. The manufacturer was notified of the failure. The failure mileage was 88,000.

The contact owns a 2011 Toyota Tacoma. The contact stated that while performing a routine engine oil change, extensive corrosion was observed across the entire undercarriage. The severe rust damage fully compromised the vehicle's structural frame, control arms, and several underbody components. The dealer was not notified of the failure, but the vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 200,000.

Chassis recall under Toyota Recall Program ZKA/LSC K0D. While the window of this recall closed in 2017, my vehicle was sold to me several years after 2017. The vehicle chassis is in a critical state and is likely to snap in half. I have sent a letter and photos to: Toyota Motor Corp., Federal Highway Admin, Toyota Clearwater, Consumer Financial Protection Bureau, FL House of Rep and BBB Natl Programs. All of the above were sent via trackable and signature required USPS. The vehicle should have been prohibited from any resale if the recall can be closed. As i understand it, technically there should be no expiration date on a significant failure. I do not have $13,000 to get a new vehicle and I do not want to resell to shift the risk to someone else. At minimum Toyota should be forced to buy back the vehicle , replace the chassis or offer a safe used replacement option. Please help me understand where I go from here. Looking for your support and resolution.

2011 Tacoma, 4x4. Leaf spring is broken on the passenger side. 130,000 miles. According to Toyota my vin is not included under recall 14V-604. I do believe this is either an error or deliberate oversight to avoid responsibility. Manufacturer date 05/11 so according to the recall notice it falls within the date range but not the effected Vins.

I purchased the truck December 6th 2025 within a thousand Miles within the end of the year I experienced brake failure on the highway I laid under the truck to patch the brake failure and found a cracked leaf spring suspension component which there's already a recall for that exact make and model just not my VIN number for that cracked leaf spring there was a recall for frame rust and just rust in general and my brake lines rusted out but a certified technician from the used car dealership said it was safe and road Worthy I experienced a brake fire on the front calipers shortly after this brake failure the fire caused 7800 worth of damage I got quoted from Toyota to fix it and that doesn't cover the $2,000 worth of leaf springs which there was already an exact recall for this exact model of truck for the exact damage depicted but somehow my VIN is not applicable for this repair.

The contact owns a 2011 Toyota Tacoma. The contact stated that while attempting to have an inspection completed on the vehicle, the contact was informed by the mechanic that the inspection could not be completed due to several holes in the underbody frame of the vehicle. The dealer was not contacted. The vehicle was not repaired. The manufacturer was informed of the failure. The manufacturer referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 168,000.

Blower Fan had been cutting off. Only running intermittent on High. Took to Toyota dealer June 2025. Was told it was a Cabin Air Filter Clogged. Paid for replacement and clean out of system. Continued to not work. Called a mechanic and asked for a diagnostic. Was told it was a “known issue” with Toyota Tacomas. Had been a recall in later years. I ordered the blower motor resistor and wiring harness from Toyota parts department. It was on back order due to the issue being widespread. July 2025 parts came in. Returned truck to the shop. The techichian replaced the motor blower resistor and the new wiring harness. However, he cut the burnt wires off and spliced the new wires into old wires back to the motor. Aug 2025 motor has stopped working again. Back to the Toyota shop. The truck needs a new blower motor. The labor will be 1200. Plus the labor I’ve already paid for three other shop visits plus parts. The motor blower is on back order till mid September. The motor has been let unplugged due to “risk of fire”. But I’ve been given the vehicle again to drive. It has had a risk of fire since June. The wires have been overheating and smelling. This should have been a recall in 2011. Just as it was in the later Toyota Tacoma. Pleas investigate

The underside of my 2011 Toyota Tacoma is experiencing tremendous rust. Dealer said since there was not perforation, nothing to be done. Brackets holding wiring, body panels and now gas tank have rusted and failed. The gas tank strap is a major concern. It is available for inspection. The gas tank is held up now by one unrusted strap and rubber bungee cords I applied. Dealer or independence service center has not seen it. Nearest dealer is a ferry ride away, I live on an island. No inspection by manufacturer etc. No warning lights or messages.