2020 BMW X5 Complaints

The AC system blowed hot air. There's must be a problem with this model because my friend also have the 2021 BMW X5 and its AC also have problem. We're suffering from this due to Manufacturing defect.

The contact owns a 2020 BMW X5. The contact received notification of NHTSA Campaign Number: 25V644000 (Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.

For my 2019 BMW X5 SDRIVE40i, The A/C evaporator core failed and began leaking refrigerant, resulting in complete loss of cold air from the A/C system. The vehicle had approximately 50,000 miles. The repair required full dashboard removal and cost approximately $4,500 including a rental vehicle. This appears to be a widespread issue on 2019–2025 BMW X5/X6/X7 models, suspected to be caused by R-1234yf refrigerant incompatibility with the aluminum evaporator core. The leaking R-1234yf refrigerant is also an environmental concern. R-1234yf is a hydrofluorocarbon (HFC) greenhouse gas with a global warming potential significantly higher than CO2. An uncontrolled leak of this refrigerant directly into the atmosphere — due to a defective factory-installed evaporator core — contributes to environmental harm and violates the spirit of EPA regulations governing refrigerant emissions. Consumers should not bear the financial burden of a known manufacturing defect that also results in the uncontrolled release of a regulated substance. BMW has not issued a recall or extended warranty for this component despite widespread owner reports of the same failure. I am requesting NHTSA investigate this issue and compel BMW to issue a formal recall and provide reimbursement to affected owners.

I own a 2019 BMW X5 xDrive40i with the B58 3.0L turbocharged inline-six engine. While driving in Minnesota, the vehicle suddenly displayed an urgent warning stating “oil pressure too low” and instructed me to stop the engine. This occurred while the vehicle was being operated on the road, requiring me to stop driving immediately. The vehicle was later inspected by an authorized BMW dealer. The dealer diagnosed the failure as a defective oil pump and stated that the oil pump must be replaced. The estimated repair cost was approximately $7,500 or more. This is a serious safety concern because a sudden loss of engine oil pressure can lead to engine seizure, loss of motive power, and loss of vehicle control risk depending on traffic conditions. The oil pump is a critical lubrication component and should not fail as a normal wear item. I have found numerous similar owner reports involving BMW B58 oil pump failures, including reports suggesting that cold-weather operation may contribute to or expose the failure. My vehicle is operated in Minnesota, a cold-weather state. The vehicle was inspected by Park Place BMW in Rochester, MN. I am requesting that NHTSA investigate whether this is a safety-related defect affecting 2019 BMW X5 xDrive40i vehicles and other BMW models equipped with the B58 engine.

Front Differential input bearing failure. Sudden jerking that almost causes loss of control. This poses a safety risk. This seems to be a know problem for the 2020 BMW X5 M50i No warning lights and I did not experience hearing any sounds as other have reported.

Plastic oil pump cracking problem is apparently known to BMW, but they haven’t recalled these defective oil pumps leading to engine failure.

The contact owns a 2020 BMW X5. The contact stated that the vehicle was taken to a dealer for routine maintenance and it was discovered that there was a coolant leak and that there was a failure with the front differential failure, and that the A/C unit was leaking. The leaking valve was replaced but the differential was not repaired. The contact stated that the failure was a known failure with the vehicle. The manufacturer was made aware of the failure. The failure mileage was 70,000.

Safety Hazard: Oil Pump Failure Leading to Sudden Engine Stall (BMW B58TU engines) Description of Defect: The oil pump module in the 2020 BMW X5 (G05) contains internal plastic components that are prone to thermal degradation and premature failure. These plastic parts can crack or disintegrate, causing a sudden loss of oil pressure. Safety Risk: A failure of the oil pump leads to insufficient lubrication of critical engine components, which can result in a sudden and complete engine seizure while the vehicle is in motion. This causes an immediate loss of propulsion and power steering assist, significantly increasing the risk of a high-speed collision or being stranded in dangerous traffic conditions. Additional Note: This is a known mechanical defect where a critical engine component (oil pump) relies on non-durable plastic materials, creating an unreasonable safety risk for drivers and passengers due to potential catastrophic engine failure without prior warning.

Safety Hazard: Oil Pump Failure Leading to Sudden Engine Stall (BMW G05 X5) Description of Defect: The oil pump module in the 2020 BMW X5 (G05) contains internal plastic components that are prone to thermal degradation and premature failure. These plastic parts can crack or disintegrate, causing a sudden loss of oil pressure. Safety Risk: A failure of the oil pump leads to insufficient lubrication of critical engine components, which can result in a sudden and complete engine seizure while the vehicle is in motion. This causes an immediate loss of propulsion and power steering assist, significantly increasing the risk of a high-speed collision or being stranded in dangerous traffic conditions. Additional Note: This is a known mechanical defect where a critical engine component (oil pump) relies on non-durable plastic materials, creating an unreasonable safety risk for drivers and passengers due to potential catastrophic engine failure without prior warning.

The contact owns a 2020 BMW X5. The contact received notification of NHTSA Campaign Number: 25V644000 (ELECTRICAL SYSTEM); however, the part to do the recall repair was not yet available. The contact stated that the vehicle failed to start. After several attempts, the vehicle started. The check control master warning light was illuminated. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was approximately 120,000.