2020 BMW X5 Complaints

The contact owns a 2020 BMW X5. The contact received notification of NHTSA Campaign Number: 25V644000 (Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that while attempting to start the vehicle, the vehicle failed to immediately start. There was a timer displayed notifying the contact when to restart the vehicle; however, the vehicle failed to start. The contact's husband inspected the vehicle and noticed that the engine was running hot despite the vehicle not being driven. The vehicle was towed to the dealer. The dealer determined that the battery had failed and needed to be replaced. The dealer informed the contact that the belts and motor mounts were damaged and might need to be replaced or repaired. The dealer also informed the contact that the part was not expected until November 2025. The starter was replaced, and a software update needed to be performed. The manufacturer was made aware of the issue. The failure mileage was 73,285.

The contact owns a 2020 BMW X5. The contact stated that while stopped at a red traffic light, the vehicle lost power. The contact attempted to restart the vehicle; however, the vehicle failed to respond as intended. A dealer was contacted. The vehicle was towed to dealer where it was diagnosed and determined that the starter needed to be replaced. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 24V576000 (ELECTRICAL SYSTEM, ENGINE AND ENGINE COOLING). The vehicle was previously repaired; however, the failure persisted. The manufacturer was notified of the failure but offered no assistance. The failure mileage was 48,000.

My 2020 BMW X5 experienced starter failure after completing recall campaign 24V-576 for starter electrical overload risk. The vehicle was subject to this recall which acknowledged a defect causing electrical overload to the starter system. I completed the required software update in late 2024, approximately 4 years after the vehicle was manufactured and exposed to the acknowledged defect. Following the recall repair, the starter system failed on three separate occasions over a six-week period. The most recent failure occurred while traveling with family, creating a safety risk by nearly stranding us in a remote location. The vehicle would not start despite multiple attempts, requiring emergency roadside assistance. The failing starter component has been diagnosed and confirmed by an authorized BMW dealership service center. The dealership provided a repair estimate of approximately $3,000 for starter replacement. The component is available for inspection upon request at the dealership. Prior to complete failure, there were intermittent starting issues with the engine occasionally requiring multiple start attempts. No warning lamps or dashboard messages appeared before the failures. The vehicle has low mileage for its age, making this a premature component failure. The timeline strongly suggests the starter damage resulted from prolonged exposure to the electrical overload defect acknowledged in the recall, as the failure occurred shortly after the 4-year delayed software remedy was applied. The manufacturer has not inspected the failed component despite the clear connection to their acknowledged safety defect.

Car would randomly not start and went dead at red stop lights on occasion. Had to have the car towed to BMW dealership where they diagnosed it as a bad starter. Car only has 35,000 miles and this appears to be a know problem by BMW and BMW owners.

Suspension "clunking noise" when going slowly over bumps. Oct. 14, 2024 32,688 miles. BMW dealer replaced left front Tension Strut due to Balljoint failure/defect @ owner expense. Tire wear indicated excessive "play" in joint for some time. I had complained to BMW dealer since the car was new that it did not track straight. Car was previously aligned several times by BMW dealer but defective ball joint was not identified until i brought "clunking" noise to their attention. Balljoint failure can result in loss of control resulting in a CRASH.

I purchased a used and well serviced, one owner, BMW 2020 X5 on [XXX] from Acura of West Chester, PA. After driving the vehicle for a week the car began jerking and shuttering forward. I live in Philadelphia where space is limited and pedestrians, children included walk close to cars at stop lights and stop signs. I almost had an accident while just parking the car due of the shuttering and additionally the car unexpectedly jerked towards a pedestrian when I was stopped at a stop sign. I researched and discovered that this is a known issue concerning my year and model due to a manufacturer error when the vehicle was assembled. The incorrect oil was place into the transfer case which ultimately causes damage leading to the unsafe driving condition that I am currently experiencing. There are no warning or check engine lights to make the driver aware of the issue. Below is the direct from BMW's notice on the issue, SIB 27 02 20. To my surprise, there was never a recall to fix this issue for the make and models affected . I am asking for the NHTSA to investigate and issue are recall for repair and replacement of the transfer case that was damaged prior to consumer purchase for the models outlined in the service bulletin. BMW replaces the oil as the first level repair at the cost of the owner which seems to only be temporary. Some owners say the problem goes away and other owners the problem returns requiring replacement as the true option. I would like for BMW to recall and replace to the vehicle safe to drive. SIB 27 02 20 JERKING OR SHUDDERING FROM THE DRIVELINE (XDRIVE TRANSFER CASE ATX13 SITUATION There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages. CAUSE Unevenly worn or incorrect fitment tires are installed on the vehicle, or the factory-filled transfer case oil does not meet BMW specifications. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMAT

Fuel pump failure. Resulted in car losing speed and power and car coming to a halt. Car went into park. Had to be towed from the road but the car had to be dragged onto the flatbed due to no parking selector release accessible from the side of the road. Resulting in total destruction of the front differential resulting in $10000 repair bill.

The contact owns a 2020 BMW X5. The contact stated that after refueling the vehicle, the contact attempted to restart the vehicle; however, the vehicle failed to restart. The contact made several attempts, and after approximately an hour, the vehicle was towed to the residence. The vehicle failed to start and was towed to a local dealer. The contact stated that there were no warning lights illuminated. The dealer diagnosed the vehicle and determined that the starter motor had failed and needed to be replaced. The vehicle was not repaired. The contact researched online and related the failure to NHTSA Campaign Number: 24V576000 (Electrical System, Engine and Engine Cooling). The contact called the manufacturer and asked about the recall for the starter motor and was informed that the VIN was not included in the recall. The failure mileage was approximately 30,000.

When it rains water comes into the drivers side from the roof (sun visor area), and under the dashboard. Depending on how much rain, it leaves a puddle on the floor mat, and constantly drips on the driver as I drive.

I own a 2020 BMX X5 S40i. Car was parked and turned off. When I tried to turn the car ON, the car refused to start and smoke and fire smell started coming from engine compartment. I opened the hood and could smell a burning smell. Waited for smell to disappear and tried starting the car again. Car would not start and burning smell appeared again. Got a warning on the dashboard that engine compartment was overheated and car would be ready to start after 180 seconds. Called AAA to jump start car and same behaviour was observed and car refused to start. Technician also stated that battery was completely dead. Took car to dealer and replaced main and start/ stop battery. Car still would not start. On inspection dealer observed started mechanism was shorted and needed to be replaced. After replacement, car starts fine without burning smell. Going through recall database, this issue with fire hazard from starter assembly is documented for my make, model and year but when I enter the VIN number it doesnt apply to ny vehicle VIN number. 4 year old child and me were occupants of the vehicle when burning incident happened originally.