2019 CHRYSLER PACIFICA Complaints

Total loss of propulsion at 35 mph and vehicle could not move in the middle of an intersection. Warnings included “Service Charging System” , “Service Hybrid System”, “Shift into Park”. Dealer replaced the inverter, check engine light and codes came back, and then dealership replaced transmission. Errors come back intermittently after transmission replaced. Has us seriously questioning the the safety of our van with 2 young kids.

When the vehicle is preparing to shift gears it almost stops like it is going to stall, then when it finally does shift gears the entire car jolts. It started off only doing it occasionally but now does this multiple times in a short 15 minute drive.

When I come to a stop(or sometimes not even fully) then accelerate to pull off, the rear end or something hesitates & then rams/jerks to the point I thought I was rear ended. This happens several times per week. Also, sometimes there’s no power when I do try proceed through light/stops. It’s like there’s little to no power for about 10 seconds. The breaks are quite loud but dealer says they are good.

The contact owns a 2019 Chrysler Pacifica. The contact stated while driving at various speeds, the vehicle would independently lurch forward and shake without warning. The contact linked the failure to an unknown recall however, the VIN tool showed no open recalls. Neither the dealer nor the manufacturer was notified of the failure. The vehicle was not repaired. The failure mileage was approximately 77,000.

On rare occasion, but enough to be concerning, the rear backup camera image will not remove from the screen after putting the van in Drive from Reverse. The last image will freeze on the screen and nothing can be done to clear the screen but stop the vehicle, turn it off fully, and then restart. Not only is it confusing to the driver to still see a non-realtime image of the back of the vehicle, any and all controls are locked out from the main infotainment screen. This has not be replicated at the dealer as it's unpredictable and somewhat infrequent. But given that there are times a full reboot of the van aren't possible (highway driving), this could be a major safety issue. No warnings are given or report from the vehicle.

While traveling on freeway loss of power and gas pedal not responding. Transmission bucks and shifts hard.

Low speed while slowing accelerating van will shift so hard that the traction control goes off. Very hard shifting. Intermittent. This has been reported numerous times since 9 speed trans were installed.

While driving on the interstate, it began to rain and proceeded to rain heavily. Initially started the wipers on intermittent low, then high, then low constant, and eventually high constant (highest setting). All of a sudden, drivers side wiper became un-synced, stuck under the path of the passenger side wiper and no longer able to clear drivers field of vision. I luckily made it on to the shoulder from the left lane and waited out the storm as I didn't feel safe getting out to inspect the situation, standing in front of my vehicle on the side of the road while visibility was reduced. Eventually made it onto an exit and proceeded to inspect what was going on, drivers side wiper was found to be loose, wiper arm retaining nut was loose and could be spun by finger. Unfortunately, no tools on hand and rain beginning to pour again, I adjusted the wiper arm to normal starting position and tightened it to the best of my ability in order to get home to properly tighten and secure the wiper arm. Seeing as this is only a 3 year old vehicle and intended to be used by families transporting loved ones, I would expect life/safety features to be performing impeccably. There is no excuse for why the wiper arm nut would come loose. I've found similar incidents reported online for this particular vehicle. Disaster was averted this time, please look into this issue and at the very least demand Chrysler inform their customers of this safety problem, it's an easy fix.

When I left work tonight, my backup camera got stuck on my screen. I couldn't clear it off. It stayed on even while driving. I had no access to the UConnect system at all. The radio power button wouldn't even work. I tried turning the car off an back on. The problem continued. Once I finally got home, I turned the car off for about 30 minutes and restarted it. The problem was then resolved. I'm worried it will happen again though. After researching, I saw that there were reports of this happening a few years ago, but apparently my VIN was not included in that recall.

Electronic Start Stop (ESS) fails to function. ESS dash warning light is on. Aux battery for ESS, when it fails, slowly drains the main battery. This is similar to the Y65 recall/vehicle campaign for this model car for years 2017-2018. Well, my 2019 and scores more are also affected by this issue, both in and out of warranty.