1997 FORD CROWN VICTORIA Complaints

The contact owns a 1997 Ford Crown Victoria. The contact stated that while driving at an undisclosed speed, the steering wheel jerked, and the vehicle became difficult to maneuver. Additionally, the contact stated that the seat belt warning light was illuminated, and other unknown warning lights were illuminated. The vehicle was towed to an independent mechanic where it was diagnosed that the lower ball joints failed and needed to be replaced. The vehicle was not repaired. The dealer was notified of the failure and the contact was informed that the vehicle needed to be diagnosed. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 170,000.

WIPER LIVE 4 IN SPOT EYE LEVEL CANT SEE IN RAIN REPLACE ARM AND WIPER BLADE STILL HAVE SPOT.

THE CAR HAS A FIBER GLASS INTAKE AND MY CAR HAS ABOUT 75,000 MILES..A FIBERGLASS INTAKE IS A DEFECTED PRODUCT FOR THIS PART OF A ENGINE,BECAUSE OF THE HEAT.I BOUGHT THIS CAR NEW AND EVEN PAID FOR THE EXTENDED WARRENTY..FORD MOTOR CO. SHOULD REPLACE THIS DEFECT PART,,FOR FREE..I HAD TO PARK MY CAR OVER 3 YEARS AGO..

HYDRAULIC LINE TO REAR BRAKE FAILED (RUPTURED) CAUSING IMMEDIATE RELEASE OF BRAKE FLUID UNDERNEATH DRIVER FRONT FLOOR PAN AT LOCATION OF INTEREST MENTIONED IN RECALL/"SAFETY IMPROVEMENT PROGRAM". OWNER WAS NOT CONTACTED REGARDING NOTICE WHICH INCLUDES INSPECTION OF BRAKE LINES, REPLACEMENT OF CLIPS (TO AVOID WEAR) AND POSSIBLE REPLACEMENT OF BRAKE LINE AND BLEEDING IF NEEDED.

TL* THE CONTACT OWNS A 1997 FORD CROWN VICTORIA. THE CONTACT STATED THAT WHEN THE HEADLIGHTS WERE ACTIVATED, THE INSTRUMENT PANEL, CLOCK, AND RADIO LIGHTS FAILED TO ILLUMINATE. THE VEHICLE WAS NOT TAKEN TO BE DIAGNOSED NOR REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 151,000.

DRIVING EAST ON ALLEN STREET IN SPRINGFIELD MASSACHUSETTS STEERING CONTROL LOCKED UP RESULTING IN A CRASH WITH A GAS STATION PUMP POLICE CRASH REPORT ID 15-3725-AC CAR WAS TOTALLED OUT WHEN IT CAUGHT FIRE NO NOISE WAS HEARD SECONDS BEFORE CRASH. I HAVE NOTICED THAT THERE WAS A RECALL ON THE REPLACEMENT PARTS BUT WONDER IF THE OEM PARTS COULD FAIL RESULTING IN CRASH.

TL* THE CONTACT OWNS A 1997 FORD CROWN VICTORIA. WHILE ATTEMPTING TO ACCELERATE, THE VEHICLE STALLED WITHOUT WARNING. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHERE THE TIRES, TIE RODS, BALL JOINTS, BRAKES, AND BATTERY WERE REPLACED. HOWEVER, THE FAILURE KEPT RECURRING. ON ANOTHER OCCASION, THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC AND THE VEHICLE WAS DIAGNOSED WITH AN UNKNOWN ELECTRIC FAILURE THAT WAS NOT REPAIRED. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS 200,000.

1997 FORD CROWN VICTORIA. VEHICLE HAS HAD REPAIRS DONE IN THE PAST AND STILL RECEIVES SAME PROBLEMS DUE TO RECALL. *TA THE CONSUMER STATED THE VEHICLE INTERMITTENTLY SHUT DOWN. A DIAGNOSE REVEALED A PROBLEM WITH THE LIGHTING CONTROL MODULE. ONCE IT WAS REPLACED, THE CONSUMER DID NOT EXPERIENCE ANY MORE PROBLEMS UNTIL THE SUMMER 2014 WHEN THE SAME PROBLEM RECURRED. AGAIN, THE LIGHTING CONTROL MODULE WAS REPLACED. *JB

A RECALL ON FORD CROWN VICTORIA 1996-1999 BUILT FROM MARCH 15 1996 - DECEMBER 14 1998 AT THE ST.THOMAS ASSEMBLY PLANT WERE PRODUCED WITH A LOWER CONTROL ARM BALL JOINT CONTAINING A ONE PIECE BEARING. THE LOWER CONTROL ARM BALL JOINT SEPARATION HAD REPORTED INCIDENTS. AFTER SPEAKING WITH FORD IT IS UNKNOWN WHY MY VEHICLE THAT WAS BUILT DURING TIME FRAME AT THE ST THOMAS ASSEMBLY PLANT WAS NOT INCLUDED ON THE RECALL. IT SHOULD OF BEEN. AFTER SPEAKING WITH FORD IT IS UNKNOWN WHY IT WAS NOT INCLUDED. THE PARTS MENTIONED ABOVE FAILED AND NEARLY CAUSING A ACCIDENT LUCKY THAT I WAS NOT TRAVELING AT A HIGH SPEED WHEN INCIDENT TOOK PLACE. I ADDRESSED THE SAFETY ISSUES FOR VEHICLES THAT FAILED TO BE INCLUDED. FORD ADVISED ME THAT THERE WAS NO REPORTING AGENCY THAT COULD ADD MY VEHICLE. THERE WAS EVERY BIT OF PROOF THAT INDEED IT SHOULD OF BEEN INCLUDED ON THAT LIST. THE AGENT VERIFIED MY VEHICLE INFORMATION AND HAD NO REASON OF WHY IT HAD NOT BEEN INCLUDED. IF YOU HAVE A VEHICLE BUILT BETWEEN THE ABOVE TIME FRAME. AT THE ASSEMBLY PLANT MENTIONED IN THIS RECALL. MAKE SURE THAT TAKE ACTION REGARDING THESE PARTS TO AVOID SERIOUS ACCIDENTS. ERROR WAS MADE ON THAT RECALL. *TR

THE THREE BOLTS HOLDING THE STEERING GEAR BOX TO THE FRAME FAILED DUE TO CORROSION ALLOWING THE UNIT TO BECOME SEPARATED FROM THE FRAME LEADING TO A LOSS OF STEERING CONTROL. *TR