GMC Complaints

View complaints related to GMC. The complaints found here are submitted by actual consumers with first hand experience. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2018 GMC ACADIA
    - Brunswick , GA

    Gear shift fails to register that it’s in fact in park position on gear shift but dash message reports “shift to park”, and warning beeping sound won’t stop and doors won’t lock. After restarting and reshifting the gears and / or pressing gear shift button up to 20 times or more until the dinging noise stops and only then can the car be locked. Everyday since 4/20/2025

    Source: NHTSA WEB SITE
  • 2019 GMC SIERRA 2500
    - BILLERICA, MA

    UI Bulletin #161b is for years 2020 and beyond. But my 2019 is having the same exact issue and the GM dealer will not cover the work as stated in the UI Bulletin #161b

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 1500
    - Port huron, MI

    I was driving the truck on the freeway and the engine completely shut off with no warning. I pulled to the side of the shoulder and I could smell a burning smell. The truck wouldn’t start back up or move in neutral. Towed it to a shop and they said it had a camshaft issue and a slight knocking noise when they got it to fire up only would run for a little then shut back off. Now I’m having to replace the whole engine due to being bad with the cam code and knocking.

    Source: NHTSA WEB SITE
  • 2022 GMC YUKON XL
    - Pawcatuck , CT

    Car would not engage in reverse. Stranded and needed a tow into dealership. Also experienced rough shifting especially when accelerating in lower gears. Dealership said It needs a new Transmission Control Valve which is a known issue with my model and there has been a recall yet my specific VIN was not included in this recall!!! Dealer says the part needed is on backorder with no listed date of when it will be coming back in stock. Quoting me $3300 out of pocket to cover this repair once they can locate the needed part. No loaner car available and this is our main family vehicle!!! They called earlier to tell me they found the needed part at another dealer but it’s now going to cost me $600 more bc they had to buy it off the other dealership. What is happening!? This is not ok! My car should be covered under the recall!

    Source: NHTSA WEB SITE
  • 2020 GMC ACADIA
    - Riverview, FL

    My 2020 GMC Acadia slt has a a warning message that pops up on the dash display which reads power steering operating at reduced assistance. Please proceed with extreme caution. At high speeds the wheel kinda pulls and is loose for handling. It also atfff conley buick out by the conley buick sericexx2020 acadias. I don't not544 lower rates of speed becomes extremely hard to maneuver . Almost zero ability to turn the steering wheel. I'm disabled and really can't afford the costly repair. It seems to be a very dangerous problem and well known to compromise ones ability to control the 2020 Acadia danalis. I had my suv ckd out at conley buick the results were power steering module needs to be replaced. When driving down the road the steering becomes dangerously loose especially

    Source: NHTSA WEB SITE
  • 2019 GMC SIERRA 1500
    - spangle, WA

    While driving down the highway experienced a partial loss of engine power causing jerky/rough operation, harsh shifting, and unpredictable behavior. Was told by the dealer service manager that it was likely a misfire in one of the cylinders. After diagnostics and servicing that included changing spark plugs, wires, and a full engine service it was later confirmed to most likely be due to a stuck lifter and will require a complete engine replacement. I have subsequently learned that this is a common problem with this L87 engine and may be an early indicator of failing crank bearings associated with a recall for later model years of my same vehicle. Seems to me that recall ought to be expanded to include earlier models with L87 engines.

    Source: NHTSA WEB SITE
  • 2024 GMC YUKON XL
    - Ocala, FL

    While driving I had a sudden loss of power. Contacted dealership and was ask for engine code light. Told them no light had appeared on dashboard. Did note intermittent shift changes while driving after this occurrence. Transmission and or engine feels like it has a studder. Concerning.

    Source: NHTSA WEB SITE
  • 2011 GMC SIERRA 1500
    - Pilot point, TX

    Vehicle experienced a catastrophic mechanical failure characterized by a percussive "shotgun blast" noise from the rear chassis, followed by an immediate, total loss of braking power (pedal to the floor) and a violent loss of directional stability. This incident represents an aggravated safety failure of known GMT900 platform defects. The technical chain of causality began with the factory exhaust manifold fasteners suffering a metallurgical shear, a universal defect documented under GM Bulletins 19-NA-218, PIP5075, and PIP4701. This shear created a high-velocity, high-heat exhaust leak directed at the brake master cylinder and vacuum assembly. This "heat soak" event compromised the engine-mounted mechanical Brake Vacuum Pump (Recall N192268490 / NHTSA 19V645) and destroyed the internal seals of the Master Cylinder (Special Coverage 15143 / NHTSA 11V599), resulting in total depletion of vacuum assist and hydraulic pressure. Simultaneously, the "shotgun blast" and violent swerve were caused by structural failure consistent with Rear Brake Caliper Bolt Fracture (GM 13247 / NHTSA 13V342) and Rear Axle Shaft/Pin Fracture (GM 14892 / NHTSA 14V819). This mechanical collapse caused the caliper to strike the wheel, resulting in a catastrophic rim blowout and immediate loss of tire pressure. Despite the vehicle having aftermarket long-tube headers installed, the root cause of the heat-related brake failure was the failure of the OEM GM manifold fasteners which snapped off in the cylinder head, as documented in the aforementioned bulletins. Under the Magnuson-Moss Warranty Act, the manufacturer remains liable for these pre-existing safety-critical defects. The vehicle is at Glenn Polk Chevrolet for a 901-series Product Allegation Investigation (Case #90199492). This report is filed to demand federal oversight into these life-threatening defects. The combo of failed fasteners, rim blowout, and compromised braking created a vehicle that was both unable to be steered or stopped

    Source: NHTSA WEB SITE
  • 2017 GMC ACADIA
    - Marlton , NJ

    In March of 2022 at around 79,000 miles, the temperature gauge was intermittently stuck on cold with the cooling fan constantly running and “steering assist reduced” displayed in the DIC. The car was found to have a bad thermostat which was replaced at the dealership on 3/28/2022. About 2 months ago the car started doing the same exact thing again. I have an appointment at the same dealership on March 23. It is likely the same problem again and I have only driven about 50,000 miles since the last time it was fixed. The car is now out of warranty. This is apparently a common recurrent with these model cars. There is in fact a service bulletin released about this very issue. GMC should replace and repair this issue since it is clearly a flaw.

    Source: NHTSA WEB SITE
  • 2020 GMC SIERRA 1500
    - Johnson City, TX

    The backup camera is too bright at night and therefore useless . Tried searching the web but found no fix that would actually work. Took my truck to the dealer and they never heard of this issue even though there are numerous articles about it on the world wide Web.

    Source: NHTSA WEB SITE