2010 HONDA CR-V Complaints

The contact owns a 2010 Honda CR-V. The contact stated that the vehicle was taken to the local dealer to be repaired under NHTSA Campaign Number: 18V661000 (Air Bags), and the dealer informed the contact about NHTSA Campaign Number 23V228000 (Structure). The dealer informed the contact that the vehicle had failed an inspection and was unsafe to drive. The vehicle was not repaired. The manufacturer was contacted and opened a case. The contact stated that a recall notification was mailed and might have been lost in transition, but no additional assistance was provided. The failure mileage was approximately 20,005.

SUDDEN ACCELERATION, while foot on the brake. This caused us to have an accident hitting cemented poles in front of a store. Our CRV was badly smashed in the front, making it undriveable. There was three of in the vehicle getting jolted and jerked. I believe this problem needs to be looked into, before someone else is hurt.

The contact owns a 2010 Honda CR-V. The contact stated that while having the vehicle repaired for a non-related issue, it was discovered that there was a failure with the rear trailing arm. The contact stated that the bolts attached to the support brackets for the trailing arm had created a hole in the frame of the vehicle. The contact took the vehicle to a dealer where it was determined there was excessive corrosion to the rear trailing arm. The dealer replaced the support bracket and replaced the bolts. The contact stated that the hole in the frame had been enlarged following the recall repair of NHTSA Campaign Number: 23V228000 (Structure). The manufacturer was made aware of the failure. The vehicle was not repaired. The failure mileage was approximately 189,168.

There was no incident involved. The airbags on passenger side are not working, according to alert on dash. I inherited this car from my deceased husband who purchased the car in Paramus, NJ. I thought this problem was fixed by the dealer at some point, but evidently was not. The car is now registered in NC, where I live. Thank you for any help you can give me to correct this problem.

American Honda Motor Co., Inc. issued a recall for our 2010 CRV. The recall identified a flaw in the design whereby "corrosion can form in the rear frame due to the accumulation of road de-icing agents mixed with mud and water. As a result, the rear frame can deteriorate, and the rear trailing arm may fall off. A detached rear trailing arm can cause a loss of vehicle control, increasing the risk of a crash or injury." (NHSTA Recall Number 23V-228) After the work was performed, we were told by a representative of the dealership’s service department that the vehicle would not pass state motor vehicle safety inspection because of the work they had performed. Over the course of August, 2023 I made more than 20 attempts (15 by email and many more by phone) to reach Honda representatives to ask them to fully repair the car so that it could pass inspection, or to repurchase the vehicle per the terms of the recall notice. Honda declined, stating that "if the brace had not been installed, we would be having a different conversation" (telephone conversation with a supervisor at Honda, August 31, 2023). The work that Honda did to address this safety recall was insufficient because, although the service team at the dealership was able to install a brace on the vehicle's rear frame, the vehicle will not pass state motor vehicle inspection, according to both Honda's dealership mechanic and an assessment by an independent certified mechanic who is familiar with this vehicle. Honda’s original design of certain parts of the frame is responsible for the excessive corrosion of the rear frame which is rendering the vehicle unsafe to drive. Since American Honda Motor Co. was not able to repair the vehicle to a safe operating condition that will continue to pass state inspection, and since the vehicle is otherwise in proper, safe, working condition, the company should have offered to repurchase the vehicle. The recall "fix" is insufficient to ensure driver safety.

1. Car got into an accident, another car hit my car front on... my Airbags never deployed but I side my front screen, it shows airbags deployed, and even button of airbags now flashes... 2. Seatbelt, malfunctions and got so tied on me that it was literally shocking me and then when I undid my seatblet, seatbelt shrunk and would not budge to work again to seatbelt myself and became short... 3. When car hit me from the front, all my brakes stopped working and my brake pedal went all the way to the floor... 4. When a car hit me, my car even overheated right away Overall problem: 1. Brakes went out after a car hit me 2. Car overheated 3. Seatbelt malfunction 4. Oil leak 5. Airbags didn't deploy but shows it did

I got into an accident and another car hot me and my seat belt got tight and now won't even come out anymore and my airbags never deployed but yet show on dashport as if it did and my airbag sign now flashes and it used to be just on off without flashing...

The door locks keep locking and unlocking at low speed or when I come to a stop

Our vehicle started to jerk whenever it is at low gear. The check engine light goes on and off. The traction control light goes on and off. And an error code came up: p060a. The vehicle has stalled 2x after moderately jerking multiple times while driving @ 50m/hr. The air conditioning blows hot air after a few minutes of it running. We have checked recalls for the particular make, model and year and it is showing the classic vehicle recalls from Honda. Unfortunately, our VIN number shows that it was not part of the recalled vehicle. We have gone through Honda hoping that they could at least do a diagnostic run and verify if it is a possible recall issue, but they will only do it if we pay for everything. Please help.

Good afternoon, I'll try to keep this as brief as possible; I'm sure you can recontact me if you need additional information. This is not an incident, rather an issue related to the current recall 23V-228 for my 2010 Honda CRV. In 1/2023, the garage advised my Honda would not pass Maine State Safety Inspection due to the severe rust on the frame and where the left rear lower control arm (LCA) attached to the frame. They advised it could detach/break off, and my ability to steer safely to a stop would be affected. I took it to the Honda dealership and they confirmed it was unsafe to drive unless the rust and frame could be repaired. The dealer did not mention this was a common problem or any upcoming recalls for this issue. In 2/2023, I found a body shop that was able to repair the corrosion on the frame and the connection point for the LCA. I paid $1600, and the car passed Maine State Safety Inspection at the same garage that identified the problem. In 5/2023, I received the Honda safety recall referenced above, which states "you may be eligible for reimbursement if you paid for recall repairs out of pocket." I called the 888 # on the recall, received an email from American Honda, and replied to their email with the documents they requested, including the repair invoice. After recontacting American Honda a second time in 8/23, and a third time in 9/23, they advised they did not receive the document in 5/23, and I should resend the repair invoice. I received a call from American Honda on 10/16/2023, during which time they stated I was not eligible for reimbursement. This was due to the fact the repair invoice did not specifically state: “Trailing arm holder kit was replaced”. My case (#XXX) was closed. I read in a Part 574 Safety Recall Report, "Owners who have paid to have these repairs completed at their own expense will be eligible for reimbursement, in accord with the recall reimbursement plan on file with NHTSA." Do I qualify for reimbursement? INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT