2010 HONDA CR-V Complaints

The contact owns a 2010 Honda CR-V. The contact stated that while driving at an undisclosed speed, the brake pedal was depressed; however, the vehicle failed to stop as intended. The engine was idling high, and the vehicle independently accelerated onto the curb. The contact stated that the brake pedal was depressed to the floorboard. The vehicle then independently accelerated and rolled backwards into a tree before coming to a stop. The contact stated that the crash had occurred in the residential parking lot. The vehicle was towed to the dealer. The vehicle was not diagnosed. The dealer repaired the damage to the structure of the vehicle. No injuries were sustained. A Police report was not filed. The manufacturer was made aware of the failure, and a case was filed. The failure mileage was approximately 100,283.

The contact owns a 2010 Honda CR-V. The contact stated while the contact's mother was driving at an undisclosed speed, the vehicle was erractically shaking. The vehicle was driven to the contact's mother's residence. The contact's mother contacted an independent mechanic. The vehicle was diagnosed with a corroded trailing arm and rear suspension. The contact was informed that the trailing arm and rear suspension needed to be replaced. The vehicle was not repaired. The contact's mother stated that a recall, NHTSA Campaign Number: 23V228000 (Structure) was performed in September 2023. The dealer was made aware of the failure. The manufacturer was not made aware of the failure. The failure mileage was unknown.

My 2010 Honda CR-V is subject to a rear subframe safety recall. The issue was initially addressed by a dealership approximately 1.5 years ago, which stated the vehicle was safe to drive. I disagreed. At Honda’s direction, I took the vehicle to another dealership, which confirmed the defect and determined the vehicle to be unsafe in October 2025. I was told the vehicle was unsafe to drive at this point. The vehicle has been out of service and has remained at the dealership since October 2025 and remains unusable. Despite this, Honda has not provided a buyback offer or any timeline for resolution. It has now been over six months since the vehicle was deemed unsafe and over a year and a half since the issue was first identified. Honda has failed to provide a remedy within a reasonable time for a safety recall, leaving me without a usable vehicle.

Cruise Control Significant safety. 2/13/2026. The first time I experienced my car made sudden high-speed acceleration, brain starts scrambling, what's going on? Ok cruise controls on, turned it off, tapped brake. Now with Cruise Control Off, I had to keep in contact with the accelerator to manually maintain speed. I had to pay much attention to my speed. Was towing a very small travel trailer, about 750#. The above actions stopped the sudden acceleration. Got my speed back under control. Thought since the problem was resolved quickly along with me disbelieving what just happened, I turned Cruise Control back ON. So, I got my speed back to where it should be and put Cruise Control ON. And, again it didn't happen right away, but when it did, it was exactly the same sudden acceleration. Vehicle to a Honda dealer next week. No warning signs or sounds, either before or after the incident, both occurrences.

Got this vehicle about a year and a half ago at full price from local dealership. It looks like it has been pieced together with many other hondas. The check engine light has been on ever since. The car keeps yet no camera. Just tried to get inspected. So far charged 2500 but was given a pass on inspection only for the light to come back on. I noticed on the back of repair paperwork this car has 2 airbag recalls. I feel duped I feel like this is attempted murder. I feel scared and sad. Something must be done with used car purchases

Odometer Fraud. The contact purchased a 2010 Honda CR-V. The contact stated that it was discovered that there was a mileage discrepancy after the purchase. The vehicle was a private sale. At the time of purchase, the vehicle mileage was 157,000 and at the time of registration, it was discovered that the mileage was 191,000.

Steering rack and pinion of 2010 Honda CR-V need to be replaced due to leaking of fluid.

The driver’s door lock will not lock or cycles up and down when trying to unlock the door. This is a 2010 Honda CR-V. There is a recall on the same part for the 2007 to 2009 Honda CR-V (Honda Service Bulletin 14-083). The recall needs to be extended to the 2010 Honda CR-V vehicle.

The rear passenger-side lower control arm mounting point on my 2010 Honda CR-V has rotted out due to severe corrosion. This has caused a loud clicking noise when driving over uneven surfaces and has compromised the structural integrity of the suspension system. The problem was confirmed by an independent mechanic, who stated that the control arm is no longer properly secured due to rust damage at the mounting point. The vehicle was also inspected by a Honda dealership, which noted frame perforation in and beyond the recall area related to NHTSA Recall No. 23V-228. Despite this, American Honda has refused to address the issue, stating that the corrosion does not fall within the defined recall area. This failure presents a significant safety risk, as the suspension could potentially detach while driving. The issue first became noticeable in mid-March 2025 when the clicking noise started and has persisted since. There were no prior warning lights or error messages. The corrosion is visible and the affected components are available for inspection upon request. The condition has been documented via dealer and mechanic reports, photographs, and video.

The contact owns a 2010 Honda CR-V. The contact stated while driving approximately 35 MPH, the stabili-trak warning light illuminated and turned off. The contact stated that there was an abnormal grinding and abnormal rubbing sound coming from the rear of the vehicle while making a left turn. The contact stated that the rear end was swaying to the left and right while attempting to manually correct the vehicle by turning the steering wheel. The contact stopped the vehicle and became aware that the rear passenger’s side tire was leaning at an angle into the wheel well. The vehicle was towed to an independent mechanic where it was diagnosed and determined that the rear suspension had separated from the subframe due to extensive corrosion of the subframe and supports. The vehicle deemed unsafe to be driven by the mechanic. The vehicle was not repaired. The manufacturer was informed of the failure. The contact related the failure to NHTSA Campaign Number: 23V228000 (Structure). The contact stated that the recall repair had been completed in 2023 by a dealer. The contact was referred back to the dealer by the manufacturer. The failure mileage was approximately 190,000.