2013 JEEP GRAND CHEROKEE Complaints

My son was hit head on in a very serious accident and his airbag on driver side didn’t fully deploy resulting in injuries. I’m not sure what component was faulty but the airbag should have fully deployed.

Was driving on highway going 60 miles following traffic my car suddenly stalled took me a little bit to pull over, switched off the car, the car made a funny sound. Waited 5 mins and the car started again. My car is constantly stalling, doesn’t give me any warning signals and the Jeep dealership I go to cannot figure out what it is. It takes about min before my car can restart and i keep moving

I will be going 50-65 mph down the highway and my jeep will just die. It will die for about 10-15 seconds then start again. This is very dangerous. I have talked to multiple people that this has happened too.

- The core component that failed is the Totally Integrated Power Module (TIPM). The failure was initiated by a fault in the external fuel pump relay (V62 Safety Recall remedy part), which caused improper power delivery. This improper power delivery subsequently damaged the fuel pump motor, requiring replacement of both components. This failure has cascaded, also disabling the circuits for the Engine Cooling Fan (Codes P0480/P0693) and Exterior Lighting (Headlights/B1630), and the Horn. I am in possession of the burnt-out fuel pump relay/fuse component. -The engine stalled while the vehicle was operating, the exact hazard the V62 recall was meant to prevent. This was followed by a catastrophic TIPM breakdown, creating new, simultaneous safety risks: Overheating/Fire Risk: The Cooling Fan circuit failed (P0480/P0693), causing severe engine overheating. No Headlights: The Headlights failed (B1630), causing total loss of visibility at night. No Horn: The Horn failed, eliminating the ability to warn other drivers. - Yes. The initial engine stall and subsequent no-start condition (due to a blown relay fuse) were confirmed by an independent service center (Monro). The cascading failures (overheating, horn, lights) and the diagnostic codes (P0480, P0693, B1630, C2201-00) were confirmed on 11/1. - The vehicle was inspected by an independent service center (Monro), who returned the failed recall component to me (relay). Recommend it go to a certified jeep dealership. It is waiting to be towed there. -The first warning was a history of intermittent starting difficulty. On 10/23, the engine stalled while operating and immediately resulted in a no-start condition. The Check Engine Light illuminated after the subsequent failed restart attempts.

The contact owns a 2013 Jeep Grand Cherokee. The contact stated while driving approximately 15-25 MPH and depressing the accelerator pedal, the vehicle hesitated before accelerating as intended. The contact stated that the brake pedal resistance increased while depressing the brake pedal, which required the brake pedal to be depressed to the floorboard. The contact stated that the Emergency Stop Brake engaged unexpectedly while the vehicle was idling and while driving at various speeds. A "Low Battery" message was displayed, and upon inspection, the battery was hot. The vehicle was taken to a certified mechanic who diagnosed failures with the TIPM (Totally Integrated Power Module) communication and the transmission; however, the vehicle had not been repaired. The contact stated that the vehicle was previously included in unknown recalls and was taken to the dealer where the recall repairs were performed. The manufacturer was made aware of the failure. The failure mileage was unknown.

Hello, I am reporting failure on the 2013 Jeep Grand Cherokee in which the drivers side headrest activated while the vehicle was not in operation and not involved in any accident. The active head restraint had activated while the vehicle was parked and in a non-running condition. No accident occurred during this time frame. The passenger side active headrest is still in the factory location and has not been activated. The drivers side head restraint has activated and can not be returned to original position. My current safety is at risk as the active head restraint is not functioning per original safety design intent. My head and neck are currently constrained in a position that causes discomfort while driving due to the location of the active head restraint. The manufacturer (Authorized dealer) has been contacted and they responded with a response including that a recall was not issued for this failure type. A warranty period was extended to 10 years from manufacture date which my 2013 has eclipsed. No inspections have been completed to date. The parts have been untouched since the date of discovery. There were no signs of this issues prior to discovery. There are no service or warning lights currently illuminated on the dash or driver information screen. This is a safety related failure and needs to be repaired by the OEM with no cost to the customer. A well documented and known issue exists and puts the owner/operator of the vehicle at a increased level of risk of injury by continuing to operate this vehicle in its current condition.

Passenger headrest popped out while driving downs the road. No accident bump or anything visible set it off. It punched out like an air bag.

Was inspected @ my local garage. The tipm goes out and you lose turn signals, wipers, transfer case control ( locks in low gear) causes airbag light to go on. And Chrysler does not manufacture them anymore. Jeep had to be towed.

There are several recalls on jeeps catalytic converter. I keep having on going issues with my grand jeep cherokee 2013. This vehicle should also have a recall like the others. This isn't cheap to fix. Can someone please help me with this on going issue with the catalytic converter. Engine light keeps coming on with the same code PO430.

I am reporting repeated safety-critical failures with my 2013 Jeep Grand Cherokee that have rendered the vehicle unreliable, dangerous, and now inoperable. I believe this vehicle suffers from a systemic electrical defect related to the Totally Integrated Power Module (TIPM)—a well-documented issue across Jeep models that causes starting failures, loss of power, and unpredictable behavior of vehicle systems. On [XXX], my vehicle failed to start. The starter clicks but does not engage. These symptoms align with known TIPM-related failures. Despite this, the authorized dealership (Madison Chrysler Dodge Jeep RAM) has refused to test the TIPM, insisting on replacing the starter without confirming the root electrical issue. This places consumers at risk of breakdowns without warning and reflects a pattern of ignoring known defects. My vehicle also has a history of major mechanical failures: Water pump, thermostat, and oil pressure unit replaced (Feb 2024) Rack and pinion, control arm, wheel hub replaced (Jul 2024) Rear brake caliper seized (Aug 2024) Radiator failure (Apr 2025) The vehicle remains with the dealership since 4/30/25. As of 5/14/25, I have received no update or repair. My case with Stellantis (Case [XXX]) has been met with repeated communication failures. I missed one call from the case manager on 5/8 and immediately returned it—leaving three voicemails over two business days and receiving no response. I was promised a callback by 5/13 and still have not heard back. These issues raise serious concerns regarding the safety and reliability of this vehicle. I am requesting the NHTSA investigate potential TIPM-related electrical defects and non-compliance with manufacturer responsibility to address safety defects. I do not believe it is safe for my vehicle to be returned to me in its current state, and I urge your agency to consider further action regarding this recurring and widespread defect. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)