MAZDA Complaints

The contact owns a 2023 Mazda Mazda3 equipped with Bridgestone Tires, Tire Line: Turanza EL440, Tire Size: 215/45/R18, DOT Number: [XXX] . The contact stated that while inspecting the vehicle, it was discovered that the front passenger’s side tire had developed a sidewall bubble and the tire was replaced. Later the front driver's side tire had developed a sidewall bubble and was replaced. The contact later discovered the same failure had occurred on the replacement tire located on the front passenger’s side. The cause of the failure was not yet determined. The manufacturer and local dealer were notified of the failure. The failure mileage was 2,500. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Transmission control module issues. Car was driving on the expressway and wouldn’t shift out of second gear. Engine light and AT light came on. Had to drive slowly on the expressway and get off on the closest exit. Cars were speeding past me and I had to be careful not to get hit. Research and shop shows the 2010 Mazda 3 vehicles have lots of issue with the TCM because they get hot due to there location.

I rinsed off the car yesterday and a day later I noticed water spots/lines in the inside of the trunk area. I wiped them down but we have another cx 50 and when I checked that one out of curiosity it has the same leaking area.

I rinsed off the car yesterday and a day later I noticed water spots/lines in the inside of the trunk area. I wiped them down but we have another cx 50 and when I checked that one out of curiosity it has the same leaking area.

Mazda vehicles currently have an infotainment system that that is touch screen when the vehicle is stopped or below 10 MPH. Above 10 MPH, the touch screen disables and can only be used with the control console. Mazda infotainment systems have a "ghost touch" issue where when stopped, will behave abnormally and select random menus, options etc. Today while stopped at a red light, this ghost touch issued caused the infotainment system to TURN OFF blind spot monitoring and smart city brake support (automatic braking.) Due to the ghost touch, the control console wheel does not over ride the ghost touch issue. I could not turn these safety features back on until I started moving the car (accelerating ABOVE 10 mph) while driving at which point the touch screen "disables" and only allows the input of the manual control wheel. Mazda is aware this is an issues and refused to recall/fix these defective units outside of warranty without charging $500 - $1000 per customer.

I have a coolant leak that I have not been able to locate. Despite replacing the radiator, the leak persists. When I contacted the dealer to inquire about estimates for changing the water pump and timing chain, they advised that it would be more cost-effective to replace the entire engine, which would require removing the existing engine at a starting cost of $5,000, with a new engine costing approximately $6,000. They suggested that if I'm already experiencing issues, it might be better to either replace the engine or consider selling the vehicle and purchasing a new one. This response implies that the dealer might be aware of a larger underlying issue and prefers not to address it directly. Experiencing a coolant leak while on the freeway can lead to serious consequences. It can cause the engine to overheat, potentially resulting in significant engine damage and a complete breakdown. This not only poses a safety risk to the driver and passengers but also to other motorists due to the possibility of losing control of the vehicle.

Back up camera display does not always immediately come on when placing car in reverse. It can sometimes be 10 -15 seconds before an image appears. I wait in the garage, driveway, or parking spot before backing but this potentially puts pedestrians behind the vehicle at risk. Per FMVSS 111 guidelines. S5.5.3 regarding response time: The rearview image "shall be displayed within 2.0 seconds of the start of a backing event." Problem has been intermittent but frequency seems to be increasing. I took the car to Headquarter Mazda in Clermont Florida. I was advised a software fix is available for the cameras but the cost would be $220 even though I have Mazda Extended Confidence warranty in effect.

The infotainment touchscreen has a ghost touch issue which causes settings to be randomly changed when the car is moving less than 5 miles per hour. This has a high probability of creating unsafe conditions as it can cause distracted drivers in stop-and-go or other slow moving traffic scenarios. Mazda is fully aware of its defective touch screens but has only addressed it with models from 2014-2016. The component has not been inspected and there were no warnings before this issue started.

Car lunged forward when lightly stepping on the gas while making a turn onto a busy street. Then it later lagged in responding when I stepped on the gas. About 5 minutes later, the car dashboard lit up and said there was a transmission error. Mechanic's diagnosis found code P0756 for a shift solenoid B stuck off. The car is unsafe to drive.

The contact owns a 2015 Mazda Mazda3. The contact stated that while reversing, the rear-view camera image was distorted, black, and failed to appear on the center display. The vehicle was taken to the local dealer, where an unknown software was reprogrammed; however, the failure persisted. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 53,953. VIN tool confirms parts not available.