GMC Complaints

View complaints related to GMC. The complaints found here are submitted by actual consumers with first hand experience. You can submit your own complaint to the NHTSA or call the Hotline, Monday-Friday 8am to 8pm at (888) 327-4236, TTY: (800) 424-9153.

  • 2015 GMC YUKON XL
    - Park Ridge, IL

    The contact owns a 2015 GMC Yukon XL. The contact stated that while driving 70 MPH and exiting the highway, the brake pedal was depressed but the brake pedal was stiff and stuck, requiring that the transmission be shifted to neutral(N), and to stand on the brake pedal with both feet. The contact continuously pumped the brake pedal, but the vehicle slowly responded and almost crashed into other vehicles. There was no warning light illuminated. The contact's wife and daughter were also inside the vehicle during the failure and were frightened and concerned for their safety during the failure. The dealer was contacted and was provided a description of the failure over the phone. The dealer informed the contact that the vacuum pump and an unknown part had possibly failed. The contact was advised that the failure was possibly related to NHTSA Campaign Number: 19V645000 (Service Brakes, Hydraulic); however, the VIN was not included in the recall, and there was no warranty coverage on the vehicle for the failure. Additionally, the check engine warning light was illuminated. The vehicle was not diagnosed or repaired due to the cost. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 143,000.

    Source: HOTLINE VEHICLE OWNERS QUESTIONNAIRE
  • 2025 GMC YUKON XL
    - Airmont, NY

    Im hearing ticking sounds when starting the engine and I reported it to my dealership service department and thay said thay don't see any issue

    Source: NHTSA WEB SITE
  • 2021 GMC SIERRA 1500
    - clarksville, TN

    I've been to the dealership a few times due to the truck jerking violently under very light acceleration when its trying to shift gears. also there was a few times that the rear wheels have locked up while driving.

    Source: NHTSA WEB SITE
  • 2017 GMC YUKON XL
    - Cedar Rapids, IA

    Engine stalling, a rough-running engine, reduced power mode (sluggish acceleration), a "Check Engine" light, or the vehicle failing to start. It started puttering really bad and died in the middle of the intersection. Check engine light came on. I got it to start, was really hard start and puttered bad then it died again and then I got it to start again, was a really hard start and puttered and died again. I was able to start it again get in the driveway but couldn’t go very fast. Check engine codes present are P2635 and P018B

    Source: NHTSA WEB SITE
  • 2021 GMC YUKON
    - Felton, PA

    Engine shut down in 2022 due to faulty lifters. Repairs were made. Same problem again in 2026.

    Source: NHTSA WEB SITE
  • 2025 GMC YUKON
    - Phoenix, AZ

    Engine failure while driving at 60mph that started with a loud knocking sound to eventual engine failure where it wouldnt turn over. Vehicle has 9600 miles and has had issues since day one of leaving lot requiring fuel injector, intake manifold gasket, lifter and rod with last fix being new coil and spark plug that supposedly fixed issue. The most recent engine failure put my family and kids in danager given 100 degree weather in middle of desert on a small highway with very limited cell service. Vehicle provided no warning lights. Vehicle was towed to dealership and I have not received an update. Vehicle has not been inspected by polive or insurance or others.

    Source: NHTSA WEB SITE
  • 2023 GMC YUKON
    - Harlem, GA

    The 6.2L motor in my GMC Yukon failed due to the camshaft and stalled me in an intersection on a highway. Had to shut the lanes down to get towed. Lost all power and couldn’t do anything but sit in the road. Just did a PICO test and it “passed” but failed 3k miles after the recall was done.

    Source: NHTSA WEB SITE
  • 2021 GMC SIERRA 1500
    - Cary, NC

    I am filing a complaint regarding a catastrophic engine failure in my 2021 GMC Sierra 1500 equipped with the 6.2L V8 engine. While driving under normal conditions, the engine suddenly failed without warning and threw a connecting rod, rendering the vehicle inoperable. There were no prior warning signs such as knocking, overheating, oil pressure issues or even a check engine light. The vehicle has been properly maintained, including regular oil changes using manufacturer-recommended 0W-40 oil. This failure created a serious safety concern due to the sudden loss of power while driving, which could have resulted in a dangerous situation, especially at highway speeds or in traffic. I am aware that General Motors has issued a recall and/or is aware of similar failures involving the 6.2L engine in certain 2021 vehicles. However, my vehicle’s build date falls just outside the currently defined recall range, despite experiencing the exact same type of catastrophic failure described in those cases. My build date is 12/20 and the recall was issued for 3/21. Given the similarity of this failure to known issues, I believe this defect extends beyond the currently identified recall population. This raises concerns that additional vehicles, including mine, are at risk of sudden engine failure without warning. I am requesting that National Highway Traffic Safety Administration investigate this issue further and consider expanding the recall to include additional affected vehicles outside the current build date range.

    Source: NHTSA WEB SITE
  • 2024 GMC SIERRA 1500
    - Clinton Township, MI

    I am reporting a safety-related defect involving the blind zone alert system. The system failed repeatedly and required multiple service visits. Initial repairs did not resolve the issue. The dealership ultimately determined the cause to be a faulty wiring harness, which has now been replaced and appears to have corrected the issue. Safety Concern: Failure of a critical safety system Increased risk during lane changes Issue persisted across multiple repair attempts Additional Concern: The delay in identifying the defect required multiple service visits and resulted in significant out-of-pocket costs. Request: Investigation into: Wiring harness defects affecting safety systems Reliability of blind zone monitoring systems

    Source: NHTSA WEB SITE
  • 2023 GMC TERRAIN
    - Antioch, TN

    Out of nowhere and driving this morning, my engine reduced power came on. Then I started losing power in the car then it died on me once out of nowhere. I managed to make it home an hour and a half later, but that could’ve got me killed stopped by AutoZone since dealerships closed today and it tells me that it’s code P228C, P0089 fuel pump. And then last night my emergency service calling came on which one I looked it up so something to do with OnStar and could be a module so I’m not sure what that is. And then you add on the fact all the sudden in the last 24 hours, my screen keeps going in and out are not working last week. My volume wasn’t working. I love this car, but it seems to have a lot of issues all of a sudden and I’m fixing to be at 60,000 miles which is a big problem considering warranty will be expired. I’ve already had issues with squeaking and squealing from the windows that they claim they can’t find nothing and I’ve had to listen to it for almost 60,000 miles. I had to get this car because my other car blew up on me and I can’t afford another new car. I’ll be taking it to the dealership first thing in the morning and I hope to God that something can be fixed cause we’re in one car Family.

    Source: NHTSA WEB SITE