GMC Complaints

Power Steering system failure warning message followed by a Stabilitrac system failure warning which caused the drivers front side brake to apply. I could not duplicate the brake application issue with the dealer but the other failures which included loss of power steering at highway speeds and lack of stabilitrac system was repeatable. A full replacement of power steering rack was performed with a front end alignment after dealing with the problem for weeks. Was told this manufacturing failure was covered for free in models newer and older than my truck (same model) but my truck was not covered. This is unsafe and not acceptable.

Was driving on the interstate when the engine stopped running. My screens went off and came on saying to press the start button to turn on as my car is still moving. Once pulled over couldn’t get the car to turn off or shift out of park. Engine never started since then. Mechanics looking at the Yukon have verified that my engine did seize up. My car is less than a year old.

The transmission is sluggish and jerky resulting in unpredictable and inconsistent speed control. The vehicle is available for inspection, if requested. The inconsistent speed control is a potential hazard during acceleration and deceleration. The issue is known to the manufacturer. No warning lamps or messages have been observed. The symptoms began to appear soon after the vehicle was purchased on 12/28/2024.

Blown motor on 2023 Yukon (after owning the SUV exactly 1 month). 3600 miles on it. Picked it up January 9, 2023, motor blown on Feb 9th, 2023. From my dealer: Tech found perform tear down on the engine- remove lower oil pan and discovery metal inside the oil pan. perform inspect on the bottom engine and found rod bearings spun- causing internal premature engine failure. Final ticket write up included: engine appeared to be “starving for oil” cylinders #5 & 6 piston rod bearings seized. Major internal engine failure. I went through the full engine replacement at a local dealer then dealt with GM for 2 months and eventually they did fully replace this vehicle with a new 2023 GMC YUKON. Luckily expedited the build as the first one took 9 months to receive. we took deliver of new vehicle in June of 2023. Can provide the new VIN if necessary. Current 6.2L has about 30k miles on it .

The control valve system on my 2021 gmc has malfunctioned and this is the second time, currently sitting at Nelson GM Dealer in Fergus Falls MN. I have to drive back to TN as thats where I live and the mechanic said this issue will happen again. This vehicle hasn't had recalls but I believe it was missed since this is the second time with this same issue. This is a GM wide issue as I have researched.

Rod and bearing failure at 80k miles. I was driving down the road and the vehicle turned off leaving me stranded on the road.there was no warning

Tailgate comes open without wanting too. Few times I've come to find the truck with the tailgate open, has occurred twice while driving. There is a recall for the same issue with the 2500 and 3500 series GMC Sierra. My truck is a 1500 series GMC. Surely same issue and faulty tailgate lock as the 2500 and 3500 trucks.

I got off work started my truck heard a few pops. As I was driving the vehicle started jerking like the brakes were being applied. Then I noticed a yellow engine light and a ESC light come on. I pulled over to check vehicle and all the lights went off. Dealer was just a few miles away. So I started back up and drove to dealer. On the way to dealer vehicle started a tapping noise. Then a new message flashed something about my steering will be affected. I got I to dealer safely. Where I left the truck for repairs.

6.2L motor shut off with no warning with message on dash to shift to neutral and press start, nothing happened. Was able to restart and drive to dealership. Truck was diagnosed with blown motor (lower bearing failure) and new motor ordered.

The motor on my 2021 Yukon completely failed while driving on a busy state road. The blown motor was replaced by a local GMC dealership, so I do not know it's status or if it'd be available to inspect. My safety was greatly put at risk. I am blessed that my wife and children were not with me, if they were, I would be even more furious. While driving on a busy state road, the tachometer dropped to zero and the truck automatically shifted into neutral. I quickly realized the engine had shutdown, and attempted a restart while coasting. The motor would not restart and I was lucky enough to coast into a nearby parking lot. Had I been in traffic, on the highway, or at a stop light, the situation could have been even more dangerous. As it was, I was stuck in below freezing temps for several hours waiting for triple A. They sent the wrong tow truck twice, and I eventually cancelled the triple A call and called a local wrecking company to come tow the car more than 24 hours later...luckily in the interim I was picked up by a family member. The issue was simply stated to me by the mechanics at the local GMC shop as the motor had "blown", they didn't know why, and they completely minimized the magnitude of the situation. To the best of my knowledge the blown engine has only been looked at by GMC employees. There were NO warning lamps or other symptoms associated with any such failure of this type - which in my opinion, makes the matter even worse and more dangerous. I am frankly furious that GMC is not doing more to address these known catastrophic issues. They have said they will not extend the powertrain warranty and I've read online that people have had their "new" motors blow the same way that the old ones did.