MAZDA Complaints

The video display board does not work properly. It randomly changes settings while driving and is very distracting and does not allow the GPS to work properly. It changes radio and display settings and any setting prev set. It cycles through them and randomly changes them The dealer (Kings Mazda in Cincinnati Ohio) stated that this is happening frequently in Mazdas and will cost over $400 for an after market fix and over $1000 for a Mazda fix. It is VERY distracting while driving

The most recent incident: Driving 35 MPH on a 4 lane divided boulevard, vehicle 5-6 car lengths in front of me indicates intention to turn right. No traffic in lane to my left should I need to change lanes. I continue to coast. At approximately 2-3 car lengths, the vehicle in front has nearly completed the right turn - there is no risk of collision - but my car BRAKES HARD. This is the 4th time my car has activated emegency braking in a situation it is not warranted. I have been dirving for 36 years with no accident. I do not need nor want this technology as it is more prone to causing accidents than preventing them. Additionally, the car throttle response is slow to recover in these situations, so while I mashed the acclerator to the floor to avoid being rear-ended - the car did not accelerate for 1-2 seconds (RPM went up, but the engine did not engage for several seconds). In situations where AEB might have been marginally helpful, detecting cross traffic running red lights, the car has NEVER detected this - and thankfully I'm an experienced driver so AEB was not needed. This technology, IMO, is not safe and will lead to over-reliance causing more accidents in the future.

Burnt oil smell started being noticed in the cabin. Checked for leaks and none was found. Took the car to the dealer and it turns out the cylinder head is cracked. Dealer acknowledged this is an ongoing manufacturing issue. I contacted Mazda corporate to see if I qualify for after warranty assistance. No engine lights are on. Car has been maintained properly.

My daughter was driving her 2016 CX5 when the coolant temperature warning message displayed on the instrument panel, advising her to pull over immediately. She had just driven on to the expressway, but luckily was still in the right lane and was able to pull over safely. If she had been in any other lane of the busy highway when this occurred it could have been a serious safety issue for my daughter and the other drivers on the highway. I contacted AAA to tow the car to my local mechanic. The service tech reported that they began by plugging their diagnostic tool into the car and they received two engine codes: P111A-00 and P011A, and that a software update must be performed first. I had the car towed to Turnersville Mazda. They said that there would be a $215 per hour diagnostic fee. They found that the thermostat needed to be replaced as it failed to open during engine operation. This service incurred a $397.55 cost. After replacing it they noticed that a milky substance was produced, indicating motor oil mixing with coolant. They recommended replacing the engine due to a crack in the cylinder head at a cost of $10,300. For some reason the service tech elected to replace the spark plugs and update the software AFTER the catastrophic engine issue was discovered, incurring an additional $330 in charges. Prior to this incident there were no issues with the vehicle, no warning lamps or symptoms of any kind.

I bought this brand new in 2018 (Aug.) and I take care of this car very well. I was in the Korean Army, and I worked at the motor pool taking care of cars and trucks. Last year, I noticed my oil level decreasing that I kept refilling. I just thought it was burning some oil. Last week, I was losing lots of oil with some smoke (oil burning). I took the car to a local shop and they said "the cylinder head appears to be leaking oil from the back drivers side of the head".

The contact owns a 2017 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated while the vehicle was parked, the rear-view camera screen failed to display an image. There was no warning light illuminated. The vehicle was taken to the dealer but was not diagnosed. The vehicle was not repaired. The manufacturer was not made of the failure. The failure mileage was approximately 50,000. VIN tool confirms parts not available.

On July 15, 2024 this vehicle at 50 mph on cruise control suddenly flashed white warning words indicating problems with the cruise control and immediately thereafter started flashing “hybrid malfunction” and to return to service dealer. At the time of the hybrid malfunction warning which was right after the quick cruise control warning, the engine operation, specifically the gas pedal no longer delivered power to vehicle, either electric or gas. Additional warning was to pull off to the side and stop and turn off vehicle. This occurred and vehicle was pulled to the side put into park and turned off. Waited approximately 3 to 5 minutes and restarted the engine which started in gas with no electric although there was electrical charge on the battery. Was able to continue to our final destination approximately 15 minutes later and no more than 10 miles driven. Hybrid malfunction was still visible on the dash to include the warning stating that vehicle needed to go to the service department. Approximately an hour later, vehicle was turned on again with the same warning about the hybrid malfunction, however, engine started in electric. Drove vehicle to dealership and stated what happened. Dealership the next day stated that this was a phantom code known by Mazda, but no problems associated with the code. Vehicle picked up per service advisors request two days later. Mazda dealership stated that headquarters had eyes on this particular vehicle. A day later after the pick up Mazda dealership requested vehicle be brought back for a “DC box” repair. Dealership stated this process would take a week or thereabouts to replace this component. Vehicle currently in dealership service.

This is the second time my car mazda -2017 had problem with fuel pump. I only saw recall for 2019 Mazda CX-9 in internet. Before the fuel pump fail, I smelled gas inside the car which I was told my mechanic later from the shop where I bought my car for immediate diagnose was considered dangerous. The first time happened 2 years ago when we were on the trip 250 miles from where we live. This time we were about 200 miles away. So the fuel pump it seemed became the problem for Mazda. When we asked Mazda about it they said it is not the same with recall for 2019. If those car has the problem with fuel pump and got the recall why Mazda 2017 did not get recalled? They said it is wear and tear but it is the same issue fuel pump. we spend $912 for original part and bought it from Mazda dealer but we couldn’t get reimbursed because they said it is not a recall. I am filing this complaint because they denied the problem with Mazda is actually and consistently fuel pump!. I have kids that I have to bring to school. Smelling gas, the car stop suddenly and lost power will get us into accident. So I am writing this to let you all know that 2017 Mazda has the same problem with 2019 Mazda which is fuel pump. Please take this seriously. Thank you

I'm filing a complaint as to substandard steel being used in the rear crossmember/rear subframe. Extensive corrosion has been confirmed upon a state inspection, which requires replacement at my personal cost. The front engine cradle was replaced in 2019, per a recall notice for the same extensive corrosion problem. A safety issue that needs to be addressed by Mazda.

My car started leaking coolant from cylinder, it is known issue for these models, unfortunately Mazda cooperation doesn’t cover the expenses, there is Service Bulletin about it, so basically so many car got affected or will affect from this problem. It is manufacturer fault, not about customer usage or mistake.