CHEVROLET Complaints

In March of 2025, my engine started knocking and had low power. I took it to a local mechanic and he said it was the classic 6.2L rod knock. I took it to the dealer in Decorah Iowa and they agreed that it was the rod knock from the recall. Since it was not covered under the recall, I had to pay almost $10,000 to have it replaced. It took over 4 months to get an engine and then it was finally replaced.

I was driving down the highway with my children to see a movie when my trucks check engine light came on and started surging and losing power we were struggling to drive 5 mph on the shoulder of the road to make it to the closest exit ramp for a safe place to stop. We were able to make it to the ramp but couldn't exit completely because it was an up hill grade. The vehicle was towed to the dealer for a complete engine replacement. The vehicle suffered from a thrust bearing failure.

I was driving home from a camping trip with my children when my truck occurred a reduce speed error on the dash and the truck went into limp mode. I found out through GM Onstar that the truck threw a PO6DD code. The vehicle was towed to dealer and the oil pressure valve was replaced and also a wiring harness.

The electric power steering system on my vehicle intermittently fails while I am driving. When the failure occurs, the steering suddenly becomes extremely heavy and difficult to control, creating an immediate safety risk to me and to others on the road. The loss of power steering has happened multiple times with no advance warning. Each time, the only way to temporarily restore normal steering is to pull over, turn the vehicle off, and restart it. The problem occurs randomly and without a pattern. The vehicle is available for inspection upon request. The issue has been evaluated by the dealer’s service center. They were not able to reproduce the failure during their inspection, but they did confirm that the vehicle had stored a diagnostic trouble code indicating a power steering failure. The service center reported that the code was too generic to determine the root cause, and no repair was performed. They acknowledged that the steering failure had occurred based on the stored code, but could not identify why it was happening. During the failures, the vehicle displays warning messages stating that both Stabilitrak and Power Steering have failed. These messages appear only at the moment of failure, with no prior warning lights or symptoms. This intermittent loss of power steering severely compromises safe operation of the vehicle, especially when turning at low speeds, entering or exiting parking lots, or navigating intersections. It puts me, my passengers, and the surrounding drivers and pedestrians at risk because the vehicle cannot be steered normally when the failure occurs.

The 2015 Chevy Traverse LTZ that I own is presenting with the same problems as many of its body style and year. The water intrusion has caused wiring to corrode in the side detection system & the drivers door wiring harness is presenting with open circuits. The LH side object module is throwing code U0233:00. They tested circuits at RH module. Found water intrusion in module, & corrosion on terminals & harness. Due to nature of location of modules, they recommend replacing LH & RH modules & harness. DTC B0085:05 current. Tested circuits & found open circuit internal to drivers door harness. Recommend replacing harness. The air bag code threw 2 days after I bought the veh 04/01/25, I attempted to contact the dealership I bought the vehicle from, AutoCredit in Hayden, ID, who admitted to the dangerous code being present, and that they were going to do nothing about it. Some time late April, my veh threw the code for side detection. On 05/27/25 I took my veh into Taylor & Sons Chevy in Ponderay, who dx my codes, and advised the above was needed. They also confirmed the fact that when that airbag code is present, that none of my airbags would deploy at time of impact if a collision occurred. This is a huge safety risk as much of my daily commute is on the hwy, and the influx of drivers in my area not familiar with the roads is increasing daily. My side detection system is a safety hazard as well due to the Traverse’s blind spots. Thank you for your time. I did not know what to do until I contacted Chevy directly who advised me to contact the NHTSA.

The contact owns a 2016 Chevrolet Colorado. The contact stated that while driving at an undisclosed speed, the steering wheel failed to steer in the intended direction. In addition, the “Service Stabili-trak” message was displayed, and the “Power Steering Failure” warning light was illuminated. The contact held the steering wheel tightly and pulled on the steering wheel, preventing the vehicle from crashing into a wall. The vehicle was driven to the intended destination. In addition, the contact stated that the vehicle was driven very slowly, and the contact used added force to steer the vehicle. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The contact referenced an unknown recall for the 2015 Chevrolet Colorado with a similar description of a failure; however, the VIN was not under recall. The contact stated that an online forum advised the contact to contact the NHTSA Hotline to report the failure. The manufacturer was not made aware of the failure. The failure mileage was approximately 130,000.

The contact owns a 2020 Chevrolet Silverado 1500. The contact stated that upon starting the vehicle, there was an abnormally loud engine camshaft bearing sound coming from the engine. The engine warning light was illuminated. The vehicle was taken to the local dealer, and after three days, it was determined that the camshaft bearing had failed, and the engine needed to be replaced. The vehicle was not repaired. The contact linked the failure with NHTSA Campaign Number: 25V274000 (Engine and Engine Cooling) and NHTSA Action Number: EA25007 (Engine and Engine and Engine Cooling). The manufacturer was contacted and opened a case. The failure mileage was approximately 45,000.

At a low speed, between 10 and 15 mph, the forward collision system automatically triggered and brought the car to an immediate stop. While we were lucky that no car was following behind us, the passenger and I experienced significant whiplash and lasting back pain as a result of this. The vehicle has not been inspected by anyone, and not been reproduced. The forward collision system flashed (red warning light, alert).

On June 27, 2025, while driving, the vehicle displayed a "Propulsion Power Reduced" warning message and a Check Engine Light illuminated. I immediately experienced a loss of power. I brought the vehicle to an authorized Chevrolet dealer the same day. On July 1, 2025, the dealer diagnosed the failure as a faulty Battery Energy Control Module (BECM) and high-voltage system fault (Code P1E00), requiring a full replacement of the high-voltage battery pack (Part #24296900). The manufacturer (GM) was contacted, and the replacement battery was ordered on July 2, 2025. As of December 2025, the vehicle remains in dealer possession (over 5 months) with no repair completed. The manufacturer has stated the part is on indefinite backorder with no ETA. The failure of this component renders the vehicle inoperable and presents a safety risk due to sudden loss of propulsion power while in motion. The manufacturer has confirmed the failure but is unable to provide a remedy within a reasonable timeframe.

The contact owns a 2008 Chevrolet Corvette equipped with Firestone Tires, Tire Line: Firehawk Wide Oval, Tire Size: P245/40/R18, DOT Number: (N/A). The vehicle was recently purchased, and three weeks later, the tire pressure warning light illuminated. The vehicle was taken to Discount Tire. The employees at that tire specialty store refused to service the tires. The contact was informed that the tires were over fifteen years old. The contact stated that the manufactured date was 4410. The vehicle was not serviced. The dealer was contacted and informed the contact that the tires met their standards for selling the vehicle. The manufacturer was not notified of the failure. The failure mileage was 52,800.